Page 2
Enduro GK more reliable and responsive steering without the fl ex. Our shock mount inserts TEAM ASSOCIATED is a Registered Trademark of Associated Electrics, Inc. with multiple mounting positions allow for precise suspension tuning whether it’s moving the shocks up, down, REEDY is a Registered Trademark of Associated Electrics, Inc.
Page 3
33.664760, -117.676533 HARDWARE 1:1 SCALE VIEW HARDWARE USED WITH OPTIONAL REPLACEMENT PART NUMBERS FLAT HEAD SCREWS (FHCS) BUTTON HEAD SCREWS (BHCS) SHIMS AND WASHERS 2.5x10mm (41088) 2.5x10mm (31350) 3x7mmx1mm (42260) 3x5mm (31530) 2.5x14mm (41077) 3x7mmx2mm (42260) 3x6mm (31531) 3x8mm (25201) Titanium (91580) Aluminum (8553) Titanium (91592)
Page 5
YOUR BUILD BEGINS HERE. GATE 01 CHASSIS BUILD: BAG 1, 2 25201 31532 Front Back 42255 3x8mm, 3x8mm, FHCS BHCS Panhard 42255 Plate 31532 31532 3x8mm 3x10mm 3x16mm Panhard 3x8mm, BHCS BHCS BHCS 91477 Mount BHCS 31532 M3 Nuts, 3x8mm, 25211 Black BHCS...
Page 6
GATE 01 ELECTRONIC MOUNTS BUILD: BAG 3 71050 25203 Hook and 3x12mm Loop Straps FHCS 42003 Battery Box, Shorty Pack GATE 02 ELECTRONIC MOUNTS BUILD: BAG 3 25225 41090 3x3mm 3x10mm 6338 Set Screw LP SHCS Antenna Tube and Cap Servo Receiver Not Included...
Page 7
33.664760, -117.676533 GATE 02 GEARBOX BUILD: BAG 4 42026 NOTE: There are optional 41078 42025 gearbox builds on page 28 Stealth X Idler 3x28mm Idler Shaft Pin Gear, 28T BHCS 2x9mm 42030 42025 Stealth X Gearbox Stealth X Gearbox Top Shaft, Rear Idler Shaft 91560 5x10x4mm...
Page 8
GATE 01 FRONT AXLE BUILD: BAG 5 41086 2.5x16mm SHCS 91560 5x10x4mm Bearing 91560 5x10x4mm Bearing 91474 7x14x3.5mm Bearing 42073 Caster Block, Left 42072 42066 Axle Housing, Pinion Gear, Front NOTE: Align the two NOTE: Install Left and 42071 42065 arrows when installing right side caster blocks Axle Housing...
Page 9
33.664760, -117.676533 GATE 02 REAR AXLE BUILD: BAG 6 71032 2.5x14mm SHCS 42019 Wheel Hex Pin, 2x11mm 42068 Drive Shaft, 42076 Rear, 80mm FT Wheel Hex, 91560 6mm, Steel 5x10x4mm 42071 Bearing Lower 4-Link Mount 41089 25225 3x6mm NOTE: Install left and NOTE: Install left and right side 3x3mm LP SHCS...
Page 10
GATE 03 LINKS BUILD: BAG 7 41078 3x28mm, BHCS 42040 Rod End, Curved 42043 25188 Link, 3x20mm, 3x20mm, 93mm BHCS 42054 NOTE: Check the rod end FT Pivot Ball, angles before installation Steel, 6mm 122.00mm 42054 25215 FT Pivot Ball, M3 Locknut, Steel, 6mm Black...
Page 11
33.664760, -117.676533 GATE 06 LINKS BUILD: BAG 7 89233 3x24mm FHCS 42043 Link, 42054 73mm FT Pivot Ball, Steel, 6mm 42040 Rod End, Curved NOTE: Build and install two rear upper links NOTE: Check the rod end angles before installation 102.20mm 25215 42260...
Page 12
GATE 09 LINKS BUILD: BAG 7 42262 Bumper Mount, 25187 89202 Rear 3x14mm, 3x12mm 89202 BHCS BHCS 3x12mm BHCS 25215 M3 Locknut, Black GATE 10 LINKS BUILD: BAG 7 NOTE: Build and install two rear trailing arms 42250 Trailing Arm, Right 25188 3x20mm...
Page 13
33.664760, -117.676533 GATE 02 DRIVESHAFT BUILD: BAG 8 NOTE: Make sure the screw NOTE: Make sure the phasing of the drive shafts is correct when installing pins are aligned with each them to the axles and gearbox. Correct Phasing female CVA during assembly Incorrect Phasing FRONT REAR...
Page 14
GATE 02 SHOCK BUILD: BAG 9 Shock Bleeding Steps: NOTE: Build 4 Pull shock shaft down. complete shocks Fill shock body 3/4 full with silicone fluid. Slowly move the shock shaft up and down to remove air from under piston. 42080 Wait for bubbles to come to surface.
Page 15
33.664760, -117.676533 GATE 01 CAGE BUILD: BAG 10 89203 3x16mm 31532 BHCS 3x8mm BHCS 42270 Fuel Cell, 42270 Bottom Cage, Rear, Right 42270 Fuel Cell, Support 42270 31531 Cage, 89202 3x6mm Rear, Left BHCS 3x12mm BHCS GATE 02 CAGE BUILD: BAG 10 31520 25211 2.5x6mm...
Page 17
33.664760, -117.676533 GATE 06 CAGE BUILD: BAG 10 31520 2.5x6mm BHCS 42271 Body Panel, Roof 42270 Body Post, Cage Cage 42271 Body Panel, Hood 25211 25211 3x10mm 3x10mm 42270 BHCS BHCS Body Mount Front 89203 3x16mm BHCS GATE 07 CAGE BUILD: BAG 10 6332 Body Clip 25211...
Page 18
Shocks 5407 O-Rings, Red, Silicone 6299 E-Clipp, 1/8” 31392 3x5x0.3mm Washer 42040 Enduro Rod Ends 42041 Enduro Pivot Balls Set 42054 FT Enduro Pivot Ball, Steel 42080 42055 FT Enduro, Shock Bushing, Steel 42056 6299 FT Enduro Pivot Ball Set, Steel, Set (28) 42081 42079 Enduro Shock Parts, Black Aluminum...
Page 19
33.664760, -117.676533 Motor Mount 1336 18T 48P Aluminum Pinion 31530 9654 Spur Gear, 87T, 48P 25391 25201 M3x8mm FHCS 25225 M3x3mm Set Screw 9654 42023 25391 FT M4 Locknuts, Blue 42023 31530 M3x5mm BHCS 41090 M3x10mm LP SHCS 42023 Stealth X Gearbox (Case, Gear cover, Spur Gear Hubs) 42023 31530...
Page 20
2308 M3x18mm BHCS 42252 25187 M3x14mm BHCS 42252 25189 M3x22mm BHCS 89202 25215 M3 Locknut 42260 42054 FT Enduro Pivot Balls, Steel 42252 42056 FT Enduro Pivot Balls, Steel, Set (28) 42250 Gatekeeper Traililng Arms 42252 42252 Gatekeeper Anti-Roll Bar Set 25215 42260 Gatekeeper Shims...
Page 27
33.664760, -117.676533 APPAREL / PROMOTIONAL TOOLS TEE SHIRTS 1111 FT Turnbuckle Wrench SP124* AE 2017 Worlds Tee, Black (S, M, L, XL-5XL) 1112 FT 4mm Turnbuckle Wrench SP126* 1114 Team Associated Tri T-Shirt, Black (S, M, L, XL-5XL) FT Dual Turnbuckle Wrench SP140* Reedy Heritage Tee, Black (S, M, L, XL-5XL) 1449...
Page 28
GATE 01 STEALTH X: BUILD CONFIGURATION: MOTOR MOUNT FACING REAR (STOCK) OVERDRIVE: Overdrive is a scenario where the front and rear wheels do not rotate at the same speed. The Stealth X gearbox is designed to allow the front wheels to spin faster than the rear wheels. Overdrive is advantageouse when climbing up rock faces because the front tires will want to pull the vehicle up the rock.
Page 29
33.664760, -117.676533 TRAIL TIPS AND CHECKLIST PREPARING TO HIT THE TRAIL: When preparing to hit the trail, it’s a good idea to have a checklist to make sure you have everything and don’t end up having to head back early. We’ve compiled a checklist of the things we think you’ll need on the trail. We’ve also left some space for you to add your specifi...
Page 30
ASSOCIATED ELECTRICS, INC. 21062 BAKE PARKWAY LAKE FOREST, CA 92630 USA CALL: (949) 544-7500 - FAX: (949) 544-7501 CHECK OUT THE FOLLOWING WEB SITES FOR ALL OF OUR KITS, CURRENT PRODUCTS, NEW RELEASES, SETUP HELP, TIPS, AND RACING INFO! WWW.ASSOCIATEDELECTRICS.COM...
Need help?
Do you have a question about the ELEMENT RC ENDURO GATEKEEPER KIT 40110 and is the answer not in the manual?
Questions and answers