Setting The Speaker Mode; Setting The Test Tone - Samsung HT-DM150 Instruction Manual

Setting the Speaker Mode

Press Cursor
1 2
button to move to
Press MENU button.
'Audio' and then
press ENTER button.
Press Cursor
In the Speaker
3 4 , buttons to move
Setup, press the
to the desired
ENTER button again.
speaker and then
press ENTER button.
•
For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL
•
For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note
•
With (Dolby Pro Logic II), the delay time may be different for each
mode.
•
With AC-3 and DTS, the delay time is set between 00 and 15mSEC.
•
Depending on PRO LOGIC and STEREO, the speaker mode may vary.
45
, ,
NONE.

Setting the Test Tone

Press Cursor
1 2
button to move to
Press MENU button.
'Audio' and then
press ENTER button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
When manually testing using the TEST TONE button
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button.
Press Cursor button
3
to move to 'TEST
TONE' and then press
ENTER button.
•
The test tone will be sent to L
R RS LS SW in that order.
If the button is pressed again at this
time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker SW: Subwoofer
R: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)
Multi-Channel Pro Logic Mode
Start
46
C