Jebao PU-36 Manual

Ultraviolet clarifier

Table of Contents

Download this manual

Mode# PU-36 Max GPH: 4400GPH Length: 19.5-inch

Positioning and Assembly

The Jebao PU Ultraviolet Clarifier is not submersible and should be positioned outside the pond where

there is little likelihood of it sitting in puddles or falling into the pond.

It is recommended (but not necessary) that the UV clarifier is attached to the tubing that enters the

external pond filter. This prevents the flow restriction caused by the UV restricting the flow of the filter.

Insert the UVC bulb into the connector. (Note: Avoid touching the bulb with bare hands and remove any

marks using a clean cloth or tissue. Oil from your fingers can reduce the life of your bulb.)

The quartz glass tube is positioned with two rubber O-rings in place. Be sure O-rings are positioned

properly to form a tight seal. Water entering inside the quartz tube may cause damage to the electrical

components.

The inlet connection is the one closest to the screw cap of the UV unit. Connect the pump tubing to this

inlet. All UVs come with 2 three-stepped adapters that fit the following internal diameter tubing (ID):

3/4", 1", 1-1/4" and 1-1/2".

Choose the hose adaptor size of the UV according to the tubing used.

Make sure that the hose adaptor for the outlet is at least as large as the inlet. Cut the hose adaptor in

the groove with hacksaw to fit the tubing selected (if necessary). Ensure that the gasket is in place

before attaching the hose adaptor into the unit.

Hand-tighten the hose coupling rings. Do not use a wrench.

Secure hoses to adaptors with hose clamps (not included).

If the water flow through the UV clarifier exceeds the recommendations, you may put a ball valve in the

tubing to restrict and regulate the flow. Place the ball valve between the pump and the UV clarifier unit.

Table of Contents

Do you have a question about the PU-36 and is the answer not in the manual?

Page 1 Mode# PU-36 Max GPH: 4400GPH Length: 19.5-inch Positioning and Assembly The Jebao PU Ultraviolet Clarifier is not submersible and should be positioned outside the pond where there is little likelihood of it sitting in puddles or falling into the pond.
Page 2 UV Clarifier - Electrical Connection Please read safety instructions before plugging the unit into the electrical outlet. When working, a purple UV light can be seen through the viewing window located in the UV housing. An operational test can only be carried out when the equipment is fully assembled. Do not test the UV while the screw cap is off the unit.
Page 3 If using only 5 to 6 months a year, replace bulb every two years. The bulb may continue to glow after 11 months of use, but its effectiveness has been greatly diminished. Replacement of Quartz Sleeves Quartz glass tubes do not need to be replaced unless they are damaged. Please handle with care, and do not leave outside in winter, since they are fragile.