Advertisement
LEC
®
IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY
KEEP ORIGINAL PACKAGING – ALL RETURNS NEED TO BE IN THE ORIGINAL PACKAGING
IN ORDER TO AVOID PRODUCT DAMAGE DURING SHIPPING. ANY DAMAGE TO PRODUCTS
NOT IN THEIR ORIGINAL PACKAGING WILL NOT BE COVERED UNDER WARRANTY.
SAFETY FIRST!
FAILURE TO OBSERVE THE FOLLOWING SAFETY WARNINGS MAY RESULT IN SERIOUS INJURY. IN ADDITION, FAILURE TO OBSERVE THESE
SAFETY WARNINGS WILL RESULT IN A WAIVER OF ALL LIABILITIES ON SUNLIGHT SUPPLY
WARNING:
• Disconnect power before re-lamping.
• When re-lamping, make sure lamp has time to cool before touching.
• Make sure power cord and lamp are connected properly.
• Do NOT hang by power cord or lamp cord.
• Do NOT make contact with the interior of the socket while the power is on.
• Do NOT operate the light systems in wet locations.
• Do NOT plug this system into a supply voltage other than what is instructed on the ballast.
• Do NOT attempt to open, rewire or reconfigure any components of the light system.
It will void the warranty and could cause serious injury or death.
• These products operate at very high temperatures. Keep away from children.
• Do not plug or unplug a power cord while the ballast is turned on.
• Read all warnings and instructions that come with your lamp
LEC
315 COMMERCIAL SYSTEM SETUP:
®
1. Remove the system from the box along with all additional parts.
2. Remove socket protector. (Fig. 1)
3. These systems do not require much setup. Attach the reflector to the fixture
using the included thumb screws. (Fig. 2)
4. Carefully insert the proper lamp into the socket making sure you line up the
pins correctly then gently twist until the lamp locks in. Please refer to lamping
installation instructions on back.
5. Hang the fixture using Kendorf Unistrut Brackets or V-hangers provided (Fig. 3).
6. Plug the unit into the proper NEMA configured receptacle or hardwire unit depending
on model voltage.
Fig. 3
315 LIGHT EMITTING CERAMIC
COMMERCIAL FIXTURE
Technical Information Guide
Kendorf Unistrut
Brackets Option
, INC. AND WILL VOID ALL WARRANTIES.
®
Fig. 1
Remove socket protector
Fig. 2
V-hangers Option
®
Advertisement
Table of Contents
Related Manuals for Sunsystem LEC 315
Summary of Contents for Sunsystem LEC 315
- Page 1 315 LIGHT EMITTING CERAMIC ® ® COMMERCIAL FIXTURE Technical Information Guide IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY KEEP ORIGINAL PACKAGING – ALL RETURNS NEED TO BE IN THE ORIGINAL PACKAGING IN ORDER TO AVOID PRODUCT DAMAGE DURING SHIPPING. ANY DAMAGE TO PRODUCTS NOT IN THEIR ORIGINAL PACKAGING WILL NOT BE COVERED UNDER WARRANTY.
- Page 2 Fig. 1 lamp base lamp-holder BULB INSTALLATION: • Use gloves or cloth to avoid handling lamp with bare hands. • The lamp base has pins with different shapes (Fig. 1). Line up the correct pins with the lamp-holder. • Carefully press down and turn 30 - 45 degrees clockwise until lamp locks in. The lamp-holder will give a snap-in sensation to confirm proper insertion of the lamp.
Need help?
Do you have a question about the LEC 315 and is the answer not in the manual?
Questions and answers