Table of Contents
Advertisement
(e). Select a correct module firmware code (i.e., 6550_Fxxx.bin for JetIO 6550)
3. Press "Upgrade" button to pop up the Firmware Upgrade console.
4. Set a proper IP address for JetIO module boot loader. Please note that the IP address
should be set to the same network segment of your PC.
5. Press the browser button
not modify the filename. Device Finder uses the filename of the firmware to identify if
the firmware matches the model of the JetI/O device.
6. Press "Upgrade Firmware" button to start upgrading the new JetIO firmware code.
7. Press "Yes" to start the progress when seeing the upgrading information popup
window. Press "No" to stop the progress.
8. The JetIO target module should be rebooted automatically after the new JetIO
firmware code was upgraded successfully.
4.6
Configuration Backup/Restore, Reset Default, and
Reboot
The backup/restore configuration function are accessed by right clicking on a JetIO module
in the network interface tree.
to select a correct JetIO firmware code. Please do
35
Advertisement
Table of Contents
Need help?
Do you have a question about the JetI/O 6510 and is the answer not in the manual?
Questions and answers