Zvox Audio SoundBase 350 Manual

ZVOX SoundBase
This guide applies to the SoundBase models 350, 450, 570, 670, 770 and 870.
It does not apply to the SoundBase 220, 320, 420, 555 and 580
The PS Menu
The SoundBase has a variety of function
and sound adjustments that could prove
useful depending on the SoundBase
owner's installation and usage preference.
The list of adjustments is called the
PS Menu.
If your TV set does not have a "internal
speakers off" feature or if your TV displays
a distracting "TV speakers off" message,
the PS menu allows you to adjust the
SoundBase and your preferred remote
control so that the volume buttons on your
preferred remote control adjust the sound
just from the SoundBase and not the TV.
These adjustments are made using the four
front panel buttons on a SoundBase while
watching the LED display. The SoundBase
remote control cannot make adjustments to
the PS Menu.
Press both buttons for three or
more seconds to trigger the PS
number adjustment mode.
Adjustment Options
®
and earlier ZVOX Audio products.
(866) 367-9869 | info@zvoxaudio.com
Adjusting the PS Menu
To make a selection from the PS menu listing,
press and hold down both the MUTE and
VOLUME UP front panel buttons for about 3
seconds. If this is the first time you have used
the PS menu, you will see the characters
"PS-0" start flashing. Immediately release the
two buttons when you see the PS number
flashing. Then quickly press and release
the Volume Up button while "PS" is still
flashing. This will increase PS number setting.
Pressing Volume Down will decrease the PS
number setting, down to "PS-0". Each time
you press the Volume Up or Volume Down
button, you have an additional six seconds to
make an adjustment.
Once you arrive at your intended PS number,
just wait for the display to stop flashing the
PS number. When the flashing stops, the
adjustment is made.
MUTE VOLUME
While flashing, the Volume Up or Down
buttons set the PS number. After adjustment,
the setting is stored when the display turns off.
®
INPUT