Changing Strap To Bungee; Charging Battery - Suunto EON CORE 2.0 User Manual

Suunto EON Core

5.3. Changing strap to bungee

You can change between the wrist strap and bungee as needed. The bungee is provided as
an option.
To install the bungee:
1. Remove both strap ends and take the springbars out of the strap ends.
2. Insert the springbars into the bungee adapters and attach the bungee adapters.
3. Thread the cord through both adapters.
4. Securely tie the ends of the bungee cord and cut off excess cord.

5.4. Charging battery

Charge Suunto EON Core with the supplied USB cable. For charging, use a USB port of 5Vdc,
0.5A as a power source. If the battery is very low, the display is off while charging until the
battery reaches an adequate charge level. When battery is so low that device cannot be
turned on, a red led is blinking next to the display. Blinking stops when battery has enough
power to start the device.
When device is on and and battery is charging, battery symbol in the upper left corner of the
display turns green.
WARNING: You must only charge your device using USB adapters that comply with the
IEC 60950-1 standard for limited power supply. Non-compliant adapters are a fire hazard and
a risk to personal injury and might damage your Suunto device.
CAUTION: DO NOT use the USB cable when Suunto EON Core is wet. This may cause
an electrical failure. Ensure the cable connector and connector pin area on the device are
both dry.
CAUTION: DO NOT allow the connector pins of the USB cable to touch any conductive
surface. This may short circuit the cable, making it unusable.
Rechargeable batteries have a limited number of charge cycles and may eventually need to
be replaced. The battery should be replaced only by authorized Suunto Service Centers.
51