Msata And Sata2 Select Jumper; Figure 4-22: Lvds Voltage Select Jumper Location; Table 4-5: Msata And Sata2 Select Jumper Settings - IEI Technology tKINO-BW Series User Manual

Figure 4-22: LVDS Voltage Select Jumper Location

4.7.6 mSATA and SATA2 Select Jumper

CN Label:
CN Type:
CN Location:
CN Settings:
Use the mSATA and SATA2 select jumper to set the priority of MSATA1 and SATA2
connectors since the MSATA1 slot is co-lay with the SATA2 connector. The mSATA and
SATA2 select jumper settings are shown in Table 4-5.
Setting
Open
Short

Table 4-5: mSATA and SATA2 Select Jumper Settings

The location of the mSATA and SATA2 select jumper is shown in Figure 4-23 below.
Page 66
J_MS1
2-pin header, p=2.54 mm
See Figure 4-23
See Table 4-5
Description
MSATA1 as the priority (Default)
(SATA2 will be disabled if an mSATA module is
installed in the MSATA1 slot.)
MSATA1 is enabled and SATA2 is disabled.
tKINO-BW SBC