Advertisement
Table of Contents
TRUE WIRELESS EARPHONES
USER MANUAL
Main User Interfaces
Earphones
Left earphone (slave)
L
1
2
3
4L
1
Earwing
2
LED indicator
3
Eartip
Charging Case
6
7L
7R
8L
8R
Charging Case Cover
6
Left earphone (slave)
7L
Right earphone(master)
7R
Right earphone (master)
R
1
2
3
4R
5
4L
Touch control(slave)
4R
Touch control (master)
5
Microphone
9
Charge indicator(slave)
8L
Charge indicator(master)
8R
Micro USB connector
9
4
Advertisement
Table of Contents
Related Manuals for Fiil T1
Summary of Contents for Fiil T1
- Page 1 Main User Interfaces Earphones Right earphone (master) Left earphone (slave) Touch control(slave) Earwing Touch control (master) LED indicator Microphone Eartip Charging Case TRUE WIRELESS EARPHONES Charging Case Cover Charge indicator(slave) Left earphone (slave) Charge indicator(master) USER MANUAL Right earphone(master) Micro USB connector...
-
Page 2: Get Started
Get Started Bluetooth Pairing Bluetooth pairing For first usage of brand new FIIL T1, please refer to page5 “Get Started” , the earphone status indicator will continue to blink blue once entered pairing mode. To begin a new bluetooth pairing, please press and hold the master earphone (right earphone) until the LED indicator blinks blue. -
Page 3: How To Control
Bluetooth Sync How to Control Auto-Sync User Interface Please refer to page5 “Get Started” , the left and right earphones will automatically get synced after Step2. Manual Sync Play/Pause Vol + Vol- 1st Step Left earphone (slave) +2sec Place the earphones into charging case , press and hold both earphones untill power off (LED indicates red then off). -
Page 4: How To Charge
How to charge How to charge Charge earphone Recharge Charging Case When earphone reminds “recharge When charging case is not able to charge headset” or the LED indicator blinks red earphone or its LED indicator blinks red, , that means battery is low and earphone it means battery low and charging case should be charged. - Page 5 FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the T1 and is the answer not in the manual?
Questions and answers