Battery And Replacement; Tips - wheeler Digital F.A.T. Wrench 710909 Instructions

The Digital F.A.T. Wrench uses a CR 2032 Lithium coin battery.
To replace the battery:
1. Unscrew the 4 screws holding the battery compartment door closed
2. Remove old battery
3. Replace with new battery
4. Replace cover and screw down snug.
NOTE: DO NOT OVER TIGHTEN
SCREWS. ONLY HAND TIGHTEN
THE 4 COVER SCREWS.
Battery Compartment
• The Digital F.A.T. Wrench is used like a screwdriver; it is not a ratcheting, click, or clutch style torque wrench
• Applying more than 120 lb-in will OVERLOAD the device and potentially damage the internal components
• The Digital F.A.T. Wrench is designed to be accurate to ±2% for entire torque setting range of 15-100 lb-in.
• The Digital F.A.T. Wrench can be used to apply torque to any fastener; it is not limited to firearms and firearm accessories
• Always protect the area surrounding screw heads with masking tape to prevent marring of metal and wood finishes
– just in case a bit slips out of the screw head while tightening
• Small, inexpensive screws can be damaged with high torque settings. Be sure to comply with recommended settings
• Small bits can be damaged with high torque settings. Replacement bits are available from many of our dealers and
through our website
NOTE: The middle screw in a guard that has three screws should only be slightly tightened. Please see the photo
below so you can better understand this instruction.
Front Screw

BATTERY AND REPLACEMENT

Battery Compartment Cover
Middle Screw

TIPS

Back Screw