Appendix; Effect Parameters; Insert Effect - Zoom HD16 Operation Manual

Effect parameters

Insert effect

CLEAN, DISTORTION, ACO/BASS SIM algorithm
COMP/LIMITER module
Type
Compressor
MXR Dynacomp type compressor.
Rack Comp
Compressor with more detailed adjustment.
Limiter
Limiter for suppressing signal peaks above a certain level.
Parameter description
Parameter name
Sense
Attack
Tone
Level
Threshold
Ratio
Release
EFX module
Type
Position
Auto Wah
Auto wah dependent on dynamics of input signal.
Tremolo
Periodically varies the volume level.
Position
Phaser
Produces a swooshing sound.
Position
Ring Modulator
Produces a metallic ringing sound. Adjusting the Frequency parameter results in a drastic change of sound character.
Position
Slow Attack
Slows down the attack rate of the sound.
Position
Fix-Wah
Changes the wah frequency according to rhythm tempo.
Parameter description
Parameter name
Position
Sense
Resonance
Level
Depth
Rate
Wave
Color 4Stage, 8State, Invert4, Invert8
Frequency
ZOOM HD8/HD16

Appendix

Sense
Threshold
Threshold
Setting range
0 – 10
Compressor: Fast, Slow
Rack Comp: 1 – 10
0 – 10
2 – 100
0 – 50
1 – 10
1 – 10
Sense
Depth Rate
Rate
Frequency
Time
Frequency
Setting range
Before, After
-10 – -1, 1 – 10
0 – 10
2 – 100
0 – 100
e
0 – 50 (Table 1)
Up 0 – 9, Down 0 – 9,Tri0 – 9
Ring Modulator: 1 – 50
Fix-Wah: 1 – 50
Parameter
Attack
Ratio
Ratio
Adjusts compressor sensitivity.
Selects compressor response speed.
Adjusts compressor response speed.
Adjusts tonal quality.
Adjusts signal level after passing module.
Adjusts threshold for compressor/limiter action.
Adjusts compressor/limiter compression ratio.
Adjusts delay until compressor/limiter release from point where signal level falls below
threshold level.
Parameter
Resonance Level
Wave Level
Color Level
Balance Level
Curve Level
Dry Mix Level
Sets connection position of EFX module to "Before" (before PREAMP) or "After" (after
PREAMP).
Adjusts auto wah sensitivity.
Adjusts resonance intensity.
Adjusts signal level after passing module.
Adjusts modulation depth.
Adjusts modulation rate. Using rhythm tempo as reference, setting in note units is also
possible.
Sets modulation waveform to "Up" (rising sawtooth), "Down" (falling sawtooth), or
"Tri" (triangular). Higher values result in stronger clipping, emphasizing the effect.
Selects sound type.
Adjusts frequency used for modulation.
Adjusts wah center frequency. Can also be controlled by pedal.
Tone
Attack
Release
Description
RTM Mode RTM Wave
Description
Level
Level
Level
RTM Sync
179