Mounting The Shield Plate And Emc Connecting Bracket - Siemens SINAMICS G120 PM240P-2 Installation Manual

Installing
3.4 Mounting the Power Modules
3.4.4

Mounting the shield plate and EMC connecting bracket

Use the shield plate provided for strain relief of the line and motor cable – as well as the
shield support for the motor cable.
If you are using the converter without filter, then you do not require the EMC connecting
bracket. In this case, attach the shield plate to the converter without the EMC connecting
bracket
If you are using a converter with integrated line filter, then mount the shield plate and EMC
connecting bracket as described below.
Note
Brake relay
If you are using a brake relay to control a motor brake, then mount the brake relay at the rear
of the lower shield plate before you attach the shield module to the converter.
Procedure - FSD and FSE
Proceed as follows to mount the EMC connecting bracket and the shield plate:
1. Attach the EMC connecting bracket to the shield plate
2. Then slide the shield module into the converter, so that it is held in the converter
the clamping spring. The shield module is located correctly if it can be easily withdrawn
out of the converter without any resistance.
3. After you have ensured that it is correctly located, fix the shield module using the four
screws
You have correctly mounted the EMC connecting bracket and the shield plate.
30
Motor holding brake (Page 81)
③
.
①
.
Hardware Installation Manual, 06/2020, A5E37800827C AD
②
by
Power Module PM240P-2