Download
Share
Print this page
Prorack K435 Fitting Instructions For Basic Carrier
  1. Manuals
  2. Brands
  3. Prorack Manuals
  4. Automobile Accessories
  5. K435
  6. Fitting instructions for basic carrier

Prorack K435 Fitting Instructions For Basic Carrier

Fitting kit
Hide thumbs

Advertisement

Quick Links

Download this manual
EN
Fitting Instructions for Basic Carrier
Revision No: 5C
x 4
x 4
x 4
x 4
1
Fitting Kit
x 4
K435
x 4

Advertisement

loading
Need help?

Need help?

Do you have a question about the K435 and is the answer not in the manual?

Questions and answers

Related Manuals for Prorack K435

Summary of Contents for Prorack K435

  • Page 1 K435 Fitting Kit Fitting Instructions for Basic Carrier Revision No: 5C...
  • Page 2 Fitting Kit K435 MAX kgs (lbs) Vauxhall Astra , 5dr Hatch 98-03 75 kgs (165 lbs) 75 kgs (165 lbs) Calibra , 2dr Coupe 89-97 75 kgs (165 lbs) 75 kgs (165 lbs) Corsa C, 3dr Hatch 00-06 50 kgs (110 lbs)
  • Page 3 Fitting Kit K435 Pontiac Le Mans , 4dr Sedan Sep 87-Mar 93 50 kgs (110 lbs) 50 kgs (110 lbs) Land Rover Range Rover , 5dr SUV 95-01 50 kgs (110 lbs) 50 kgs (110 lbs) Range Rover , 5dr SUV 95-01...

  • Page 4: First Time Installation

    Fitting Kit K435 First Time Installation Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. This kit fits type A, B, C and D. These instructions show type A crossbar fitted. They also apply to type B, C and D.
  • Page 5 Fitting Kit K435 Use hex screwdriver to reverse adjusting screw 10 turns. Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment. Ensure each end of the crossbar is adjusted equally. Set bars to length (refer to the crossbar instructions for crossbar adjustment).
  • Page 6 Fitting Kit K435 Tighten adjusting screw to 5 Nm (3.7 ft lb). Remove plastic clamp block by gripping bar leg with fingers and push firmly with thumbs until clamp block drops out behind leg. Select plastic internal block (from fitting kit) and insert into foot.
  • Page 7 Fitting Kit K435 Fit rubber pads (supplied with fitting kit) to foot. Pad may vary in shape to that shown. Make sure the pad fits into the holes underneath the foot. Open fixed point cover by sliding with downwards pressure.
  • Page 8 Fitting Kit K435 Locate clamp onto seam flange as shown (hook outboard, blade inboard). Ensure hook is engaged under flange return and clamp blade is behind the flange. Repeat for all four positions. Place crossbar foot over clamp. Fixed-point opening should be covered by the pad.
  • Page 9 Fitting Kit K435 Place one hand on the leg and apply downward pressure. Tighten the red plastic knob. Ensure the red plastic knob is in the position shown when fully tightened. Repeat for all legs. Check crossbar is securely attached to the vehicle.
  • Page 10 Fitting Kit K435 CAUTION: Recheck all fasteners immediately after a load is applied to the crossbars. Regularly check screws are tight.

  • Page 11: Maintenance

    Fitting Kit K435 Maintenance Clean the car roof and surfaces of the product that will be in contact with the car roof. Follow the fitting instructions for fitting the product to your vehicle. Make sure all steps are carried out in order.
  • Page 12 Fitting Kit K435 Check and replace worn out or defective parts. Keep the product clean and maintained. Never drive into a car wash with the roof rack system fitted. Lubricate locks and adjusting screws at regular intervals. Remove the products from the vehicle when not in use.
  • Page 13 Fitting Kit K435 Astra, 5dr Hatch 98-03 (EU) -140mm 510mm 770mm 775mm -5 -1/2ths" 20 1/16ths" 30 5/16ths" 30 1/2ths" Astra, 5dr Hatch 98-03 (EU) -140mm 510mm 770mm 775mm -5 -1/2ths" 20 1/16ths" 30 5/16ths" 30 1/2ths" Astra, 5dr Hatch Dec 98-Jun 04 (NZ)
  • Page 14 Fitting Kit K435 Cielo, 3dr Hatch Sep 95-Jul 98 (NZ) Cielo, 4dr Sedan 94-98 (EU) Cielo, 4dr Sedan 95-97 (ZA) Cielo, 4dr Sedan Aug 95-Apr 98 (AU) Cielo, 5dr Hatch 94-98 (EU) Cielo, 5dr Hatch Aug 95-Apr 98 (AU) Cielo, 5dr Hatch Sep 95-Jul 98 (NZ)

  • Page 15: Warranty And Disclaimer

    Make a claim as soon as practicable by contacting the Prorack dealer from whom you purchased the product, who will give you instructions on how to proceed. If you are unable to contact the Prorack dealer, or the dealer is not able to remedy the defect, you should contact Yakima as soon as practicable at: Call: 0800 4776 722 (NZ) or 1800 143 548 (AU) Email: warranty@yakima.co.nz or warranty@yakima.com.au...
  • Page 16 Yakima or the Prorack dealer will be borne by you. Following receipt of the product and purchase invoice or receipt, Yakima or the Prorack dealer must inspect the product to determine whether the claim falls within the warranty. If: 4.1 the claim falls within the warranty, Yakima will remedy any defects in materials or workmanship becoming apparent during the...