Troubleshooting; Warranty - Allen + Roth 41997 Quick Start Manual

TROUBLESHOOTING

PROBLEM
Fixture does not light.
Fixture stays on
continuously.
Fixture light blinks on and off.
TWO-YEAR LIMITED WARRANTY
The manufacturer warrants all of its lighting fixtures against defects in materials and workmanship
for two (2) years from the date of purchase. If within this period the product is found to be defective,
take a copy of the bill of sale as a proof of purchase and the product in its original carton to the place
of purchase. The manufacturer will, at its option, repair, replace or refund the purchase price to the
consumer. All costs of installation and removal of the fixture is the responsibility of the consumer. This
warranty does not cover fixtures becoming defective due to misuse, accidental damage or improper
handling and/or installation and specifically excludes liability for direct, incidental or consequential
damages. As some states do not allow exclusions of limitations on an implied warranty, the above
exclusion and limitation may not apply. This warranty gives you specific rights and you may also have
other rights which may vary from state to state.
9420 PB · 081619
POSSIBLE CAUSE
1. Fixture may be wired
incorrectly.
2. Worn or broken bulb.
3. Fixture is set to Auto
Mode.
1. Fixture is not set to Auto
Mode.
2. There is motion in
detection area.
3. Shut-off settings are
incorrect.
1. Fixture is overheated.
2. Sensitivity is set too high.
10
CORRECTIVE ACTION
1. Check wiring.
2. Replace bulb.
3. Cover sensor to simulate
darkness.
1. Reset fixture by turning the
power off and on.
2. Make sure there is no motion
in the detection area.
3. Turn TIMER knob
counterclockwise to shut-off
delay time.
1. Make sure the light is not near
a heat source.
2. Reduce the sensitivity to
avoid undesired triggering
by passing cars or refecting
objects.
Printed in China