Table of Contents
Advertisement
Turn the System All On (All On or Cmd 1)
Exit Delay Time (to be filled in by your security company).
You have __________ sec. to exit premises before system turns on.
Use this command to turn on the entire system. Once you press the [ALL ON] key or enter Cmd 1, the Exit Delay timer
starts its countdown. The length of exit delay is programmed by your security company.
When your system is ready to turn All On, it displays OK for All On, indicating all points are normal, such as no open
doors or windows and no one standing in front of a motion detector.
If your command center displays a message indicating the system is not ready to arm (such as Not Ready to Arm),
check all doors and windows to see if any are open or if someone or something is in front of a motion detector. If all
protected doors and windows are closed and no motion detectors are blocked and the command center still displays Not
Ready to Arm, contact your security company for assistance.
In the example below, the exit delay is 60 sec. Leave before the exit time expires. Leaving after exit delay expires causes an
alarm event.
1.
Make sure all points are normal (not faulted). If your system has a faulted point (door/window open), you
can either close it or bypass it (see Bypass Points 1 on page 18).
2.
Press [ALL ON] or [CMD] [1]. The command center may prompt you to enter a valid passcode.
3.
Enter your passcode if necessary. Exit delay time begins. The On indicator turns on. Exit the building now.
Enter your passcode to stop the system from turning on during the exit delay.
Press [BYPASS] to bypass points (see Bypass Points on page 18). You can turn the system All On with No Delay
by pressing [NO DELAY]. You can also turn the system Part On by pressing [PART ON]. The system prompts
you through this procedure.
4.
During the last 10 sec. of Exit Delay, the command center displays Do not exit! and emits a double tone
every second to warn you not to exit and to turn the system off. The system turns All On. The On indicator
remains on steady.
5.
To turn the system off, enter your passcode.
© 2003 Bosch Security Systems
Smiths Residence
Ok for All On
60 seconds to
All On.
To bypass points
Press Bypass
For no delay
press No Delay
For Part On
press Part On
Smiths Residence
All On
D623/D625 User Guide
Page 11
Security System
User Guide
46841D
Advertisement
Table of Contents
