Advertisement
Inserting SIMMs
From the illustrations showing the possible SIMM
combinations decide which SIMM capacity will be installed
in each slot. Then, working from the socket nearest the
rear of the system unit towards the front, install the
SIMMs.
To fit a SIMM:
1. Hold the SIMM so that the memory chips are facing
the rear of the system unit with the metal connector
strip nearest the system board.
2. Position the SIMM above the socket at an angle of
about 15°.
3. Lower the SIMM towards the socket. The right edge
of the SIMM will be prevented from reaching the
connector by the securing clip.
4. Allow the left edge of the SIMM to drop into the
connector.
5. Push the SIMM gently to the right and lower the
right edge into the connector.
6. Ensure that the SIMM is properly located in the
connector.
12
Advertisement
