Husqvarna 322HD60 Operator's Manual page 5

• Use sturdy non-slip boots or shoes.
• Use clothing made of a strong fabric. Always use
heavy, long pants and long sleeves. Do not use
loose clothing that can catch on twigs and branches.
Do not wear jewelry, short pants, sandals or go with
bare feet. Put your hair up safely above shoulder
level.
• Keep first aid equipment close at hand.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring operates correctly.
A
1073 - 004 -
B
2. Push down the throttle trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Release the throttle trigger lockout and make sure
that the throttle trigger is locked at idle speed
position.
4. Start the engine and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop fully.
WARNING: If the blades move when the
throttle trigger is in the idle speed
position, adjust the idle speed. Refer to
To adjust the idle speed on page 10 .
To do a check of the stop switch
1. Start the engine.
2. Push the stop switch to the stop position and make
sure that the engine stops.
WARNING: The stop switch automatically
goes back to start position. To prevent
accidental start, remove the spark plug cap
from the spark plug when you assemble or
do maintenance on the product.
5