Attaching The Handle; Adding Oil - Pittsburgh Automotive 64542 Owner's Manual & Safety Instructions

Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Assembly Diagram on page 6.

Attaching the Handle

CAUTION! The Handle may contain a spring under tension. Wear ANSI-approved safety goggles
before loosening or removing Handle. Remove Handle carefully.
1. Fasten the Upper Handle to the Lower Handle.
2. Loosen the Set Screw and insert the
assembled Handle into the Handle Socket.
Bleeding
1. Loosen the Fill Screw.
2. Turn the Handle counterclockwise
to open the Release Valve.

Adding Oil

1. Remove Fill Screw and Screw, see
Figure B: Hydraulic Unit.
2. Add high grade hydraulic fluid into the Fill Screw
slowly until the oil reaches the top of the oil fill hole.
Functions
Saddle
Carry Handle
64542
Handle
Oil Fill Screw
(Not Shown)
Figure A
For technical questions, please call 1-888-866-5797.
3. Tighten the Set Screw.
3. Pump the Handle up and down quickly several
times to purge air from the system.
4. Tighten the Fill Screw.
Note: Do not touch the Handle when
adding the hydraulic oil.
3. Replace the Fill Screw and Screw.
Cover Screw for
Safety Valve.
Do not open
or adjust.
Handle
Socket
Screw
Fill Screw
Figure B: Hydraulic Unit
Page 3