ITOH DENKI F-RAT-NX75 User Manual page 17

Wiring for HBM-201
17
4. Wiring
〔HBM-201〕
M3：Drive switching
Power connector (CN1)
Control connector (CN2)
Connecting to driver cards
F-RAT-NX75 Annex User Manual for IB-P02F-P-FT
Wiring for HBM-201
HBM-201
■ Connector descriptions
#2 0V
CN1
（Power）
#1
24V DC
#2 0V
#1 24V DC
Functions
Carrier wheel surface
#5 Input
switch input
Roller surface
#4 Input
switch input
CN2
#3
Unused
（Control） −
Carrier wheel surface
#2 Output
standby output
Roller surface
#1 Output
standby output
#1 #2 #3 #4 #5
Connect the 24V DC and 0V cables to CN1
1
(2 pin).
Do not connect multiple power cables to one
■
pole. Failure to follow this could result in
electric shock, short circuit, and/or damage
due to the capacity of connectors being
exceeded. (Connector capacity: 10A)
Do not connect the 24V DC and 0V cables
■
incorrectly.
Do not connect cables when connectors are
■
plugged in.
Connect the above four cables.
2
Use the same voltage to be input to CN2#1 as
■
the power supply voltage.
(Connector capacity: 4A)
Connect the power connector (CN1), and control
3
connector (CN2) to driver cards.
＊ Teaching
Operation to perform the initial setting of the transfer surface position.
Teaching must be performed after the power is turned on.
Term
CN1
0V
N/A
24V
0V
0V
24V
24V DC
1 2 3 4 5
CN2
HBM-201BN：0V
（ ）
｝ IN
HBM-201BP：24V
HBM-201BN：0V
（ ）
｝ OUT
HBM-201BP：24V
Detailed descriptions
・Carrier wheel and roller transfer surface are switched by inputting
signal
・Teaching settings can be performed when both #4 and #5 are ON
＊
・Teaching has not completed when both #1 and #2 are ON ＊
(when the power is turned on)
・Transfer surfaces are being switched, and teaching is in operation
when both #1 and #2 are OFF
・Open collector output
Power connector
(CN1)
0V
24V DC
7mm 0.50〜1.5mm
2 （AWG:20〜14）
Control connector
(CN2)
7mm 0.08〜0.5mm
2
（AWG:28〜20）
Original notice - U1.1