Related Manuals for Ferroli TIBER B Series
Summary of Contents for Ferroli TIBER B Series
- Page 1 TIBER B TIBER B 30 S TIBER B 50 S TIBER B 50 TIBER B 80 TIBER B 100 TIBER B 150 TIBER B 80 H TIBER B 100 H ATENTION! DO NOT CONNECT TO THE MAINS BEFORE FILLING, ASIRREVERSIBLE DAMAGE TO THE APPLIANCE MAY OCCUR.
- Page 5 Ferroli TIBER B water water Ferroli TIBER B...
- Page 7 TIBER B TIBER B TIBER B TIBER B TIBER B TIBER B TIBER B TIBER B 30 S 50 S 80 H 100 H (bar) 230V~50/60Hz 100.0 135.0 Vertical installation (H)-Horizontal installation...
- Page 8 TIBER B 100-150L MODELOS(mm) NUMBER TIBER B 30S TIBER B 50S TIBER B 50 TIBER B 80 TIBER B 100 TIBER B 150 TIBER B 80H TIBER B 100H ф368 ф368 ф438 ф438 ф438 ф438 ф450 ф450 1280 1104 1/2" 1/2"...
- Page 9 TIBER B...
- Page 10 Model TIBER B 30S TIBER B 50S TIBER B 50V TIBER B 80V TIBER B 100V TIBER B 150V TIBER B 80H TIBER B 100H E(mm) 1104 F(mm) L(mm)
- Page 12 Heating indicator 1- Flashing: anti bacteria function enabled; 4- Temperature display / Countdown setting display / Normally on: constant temperature mode Hour value display 2- Power key 6- Mode key 3/5- Adjustment key Short press: countdown appointment mode / constant short press: adjust;...
- Page 13 2-colour indicator light Constant temperature function； Red LED Anti-Legionella function, Red LED (6/7) flashes Shutdown and power on function, Green LED STANDBY button “-“button Temperature display “+“button Mode selection button (Reservation mode/ constant temperature / ECO mode Count down appointment mode. Red LED(6) light up During the heating stage, the decimal point in the lower right corner of the LED digital tube will flash and display until the set temperature is reached, the decimal point goes out.
-
Page 14: Appointment Function
APPOINTMENT FUNCTION Continue to press the button. to enter the appointment mode. Press the mode key to switch to the countdown reservation mode, (6) light flashes. Countdown reservation function, in the countdown reservation mode, the electric water heater will be heated to the set temperature in advance according to the time point reserved by the user. - Page 16 If there is a malfunction, the unit will enter “fault mode” and 4 will display the corresponding fault code. Cut off the power and start the water heater again, if the fault has been removed. The heater will rwsume normal operation. If this is not the case, 4will continue to display the fault code. The type of malfunction will be indicated by the 4 as follows”...
- Page 17 Ferroli...
Need help?
Do you have a question about the TIBER B Series and is the answer not in the manual?
Questions and answers