Qube Is Reporting To Avl2 But Displays "Power Up + Ignition On" Icons; Qube Is Reporting To Avl2 But Does Not Have Any "Ignition Off" Events; Qube Is Reporting To Avl2 But Has Multiple "Ignition On / Ignition Off" Events - Navman Qube 300 Installation And Troubleshooting Manual

1 Installation and Troubleshooting Guide

1.13.4 Qube is reporting to AVL2 but displays "Power up + Ignition On" icons.

This condition is most likely caused by improper connections of the Qube's power wires to
vehicle circuits. The installer may have connected the constant +12V wire or the ground wire
from the Qube's power harness to a switched source in vehicle. In some cases, the constant
+12V and the ignition wires are connected in reverse.
Use mutimeter to verify wiring connections to Qube's constant +12V, ignition and ground wires.
NOTE: during initial installation, improper power/ignition wire connections may prevent the
Qube from waking up/coming online)

1.13.5 Qube is reporting to AVL2 but does not have any "Ignition Off" events.

This condition is most likely caused by improper connections of the Qube's power wires to
vehicle circuits. The installer may have connected the ignition wire from the Qube's power har-
ness to a constant +12v source in vehicle.
Use mutimeter to verify wiring connections to Qube's constant +12V, ignition and ground wires.
1.13.6 Qube is reporting to AVL2 but has multiple "Ignition On / Ignition Off"
events.
This condition is most likely caused by, either poor/loose connection of the Qube's ignition wire,
improper selection of a "true" ignition source, or low/drained vehicle's battery (i.e. during
engine crank).
If the vehicle has trouble starting and/or running, advice customer to see a qualified mechanic.
If the vehicle does not have problems starting and/or running, verify that Qube's ignition wire is
connected to a "true" ignition source and not an accessory circuit (if connected to an accessory,
AVL2 may display ignition "ON-OFF-ON" every time the vehicle is started).
Check the Qube's ignition wire connection, if loose, move and/or rewire this connection.
Check connections at the ignition fuse holder and test ignition wire pin at the Qube's power con-
nector.
32