JABSCO 58500 Series Quick Start Manual

Lite Flush Electric Toilets
FEATURES
• Space saving stylish design
• Compact size, rotatable seat
• Virtually silent operation
• Choice of leaving bowl wet or dry after use
• Non-clogging large bore flush pump macerates waste
• Uses less than 1.0 amp/hour per day
• ISO 8846 MARINE - Ignition Protection
MODEL RANGE
Description
Foot-
Lite Flush
switch
12V
Variant
(11 kg, Lite Flush
24 lbs) 24V
Lite Flush
Control
12V
Panel
Variant
Lite Flush
(11kg,
24V
24lbs)
Foot-switch controller
CAUTION:
When power is first applied to the unit,
the flush pump will always activate to
discharge the contents of the bowl.
The lite flush toilet offers a single touch fully automatic
foot-switch operation.
• The first press of the foot-switch activates the rinse
pump and adds approximately 0.6 Litres, less than
1/5 of a us gallon, of water to the bowl.
• The second press of the foot-switch activates the
rinse pump adding a further 0.6 Litres, less than 1/5
of a us gallon, of water to the bowl and then
operates the flush pump, discharging the contents
and leaving the bowl dry.
This is the complete 2 stage flush cycle. You may
decide to leave the bowl dry or, by pressing the
foot-switch once more, leave the bowl wet, ready
for the next user.
Note: The correct use of the toilet is to;
1. Press the foot-switch and add water to the bowl
2. Use the toilet
3. Press the foot-switch to add water and
4. Then discharge
Part no. Fuse/
Breaker
58500-0012 25 amp
58500-0024 15 amp
58500-1012 25 amp
Touch pad controller
58500-1024 15 amp
The lite flush toilet features a
multi-function 'one touch' control
pad offering four options - 'fill',
'quick flush', 'flush' or 'empty'.
In addition, the owner can set the control at any time
so that the bowl is left either 'dry' or 'wet' after flushing.
The recommended 'dry' setting minimises total water
usage. If water usage is not a concern, the 'wet' setting
automatically adds 1 quart (1 litre) of water after
flushing, ready for the next user.
Simultaneously holding down both 'quick flush' and
'flush' buttons for 5 seconds switches between bowl
always left 'dry' and bowl always left 'wet' modes.
•
•
•
•
•
1
Models 58500-Series
'Fill' may be touched when the bowl is 'dry' to add
1 quart (1 litre) of water before use, if thought
necessary.
'Quick flush' first rinses and then empties the bowl
after light use. On 'dry' setting, this uses less than
1 quart (1 litre) of water.
'Flush' rinses and empties the bowl twice after heavy
use. If the bowl is 'dry', touching 'fill' first is
recommended. This uses just 2.5 Quarts (2.5 Litres)
of water.
'Empty' does exactly what it says without adding
any water, whenever desired.
Even when the bowl is apparently 'dry', there is an
anti-odour water lock in the pump housing.