Iflash; Iflash Pc Introduction; System Prerequisites; Program Menu - Hirschmann PAT DS 85/0002 Calibration Manual

10
3

iFLASH

3.1

iFLASH PC introduction

iFLASH PC supports the user in the terminal, uploading, and downloading BRN files.:
iFLASH PC is a program for Microsoft Windows operating systems as of Windows 98. The user and
control system primarily communicate via a terminal program by using a serial interface. Within the
terminal program, basic functions can be executed using the menu selection. Furthermore, iFLASH
PC supports the user with additional dialogs for easy operation of the system, especially when
exchanging data.
iFLASH PC is a software toolbox used for configuration, start-up and service of PAT devices with
RTOS operating systems such as iFLEX5, DS85, SLI, ECIS and ¼" VGA console.
3.2

System prerequisites

To install iFLASH PC on a PC, the following conditions should be satisfied:
•
PC min. 486 / 100 MHz
•
Operating systems:
•
Windows 98 or higher
•
Windows NT4 with Service Pack 6
•
Windows 2000 or higher
•
Memory:
•
15 MB free memory on hard disk
•
min. 32 MB RAM
•
Graphics:
•
VGA graphic card
•
Resolution 800 x 600 (1024 x 768 recommended).
•
RS232 interface
3.3

Program menu

The Menu program contains the actual work functions for exchanging data with iFLEX5.
These are:

3.3.1 Terminal

The terminal window is the communication center for the system. All outgoing messages from the
system are shown in this window, allowing for troubleshooting system inputs, output, and sensors.
031-300-190-169 REVISION B 01/06/04
Calibration Manual
190169_B
DS85