Toro Z Master G3 Setup Instruction

Z Master
for International Z Master
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® G3 Mowers
®
Description
No parts required
No parts required
Rear wheels
Rollover Protection System Kit (ROPS)
Seat
Seat plate
Flange nuts (3/8 inch)
Spacers (3/8 inch)
Seat
Flange nuts (3/8 inch)
Long spacers (deluxe seats only)
Short spacers (deluxe seats only)
No parts required
Right control lever
Left control lever
Bolt (3/8 x 1 inch) (2 are assembled)
Nut (3/8 inch) (2 are assembled)
Carriage bolt (3/8 x 1-1/2 inches)
Flange locknut (3/8 inch)
Air cleaner cap
Hose clamp
Clamp
Wing nut (1/4 inch)
Battery hold down
No parts required
No parts required
No parts required
Number 2 general purpose lithium base
or molybdenum base grease. (Purchase
separately.)
No parts required
Register at www.Toro.com.
G3 Mowers
Qty.
–
–
2
1
1
1
8
4
1
4
2
4
–
1
1
4
4
1
1
1
1
1
2
2
–
–
–
1 tube
–
Form No. 3362-716 Rev D
Setup Instructions
Use
Remove parts from the crate.
Check the tire pressure.
Install the drive wheels.
Install the Rollover Protection System
(ROPS).
Install the seat (Models that have a fixed
or non flip up seat).
Install the seat (Models that have a
Tilting or Flip Up Seat).
Check the seat belt.
Install the motion control levers.
Install the lift assist pedal.
Install the air cleaner cap.
Install a Battery (Model numbers that
end with CP only)
Charge the battery.
Check the engine oil level.
Add fuel to the machine.
Check the machine for grease.
Prepare the side discharge chute.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved