Husqvarna 122C Workshop Manual page 52

7
50
Crankshaft and crankcase
Full engine assembly sequence
1. Crankshaft with attached piston in
the crankcase.
2. Flywheel on the crankshaft.
3. Drive cup on the crankshaft.
4. Centrifugal clutch on the fl ywheel.
5. Cylinder.
6. Ignition module, air gap adjustment.
502 51 34-02
7. Carburettor distancer/heat shield
against the cylinder. Tighten the four
screws crosswise and diagonally.
8. Muffl er with gasket.
Check and replace if required the
spark arrestor on the muffl er.
9. Fuel tank.
10. Carburettor, complete with air fi lter
holder.
Check that the choke lever arm fi ts
the channel on the choke control
(see also the "Fuel system" chapter
if required).
11. Assemble the clutch cover and make
sure that the brass bushes are not
misplaced and that the ignition cable
and the short-circuit cable are inser-
ted in their cable channel.
12. Fit the cylinder cover.
NOTE!
Three of the eight screws are
fi nely threaded and must be used
for tightening the cover against
the crankcase.
13. The air fi lter (oiled), the air fi lter
cover and the spark plug.
531 00 60-76
0.3