ALDI FERREX XG-KF2000 User Manual page 19

Digital Inverter Generator with Pure Sine Wave
3. Power Supply indicator (Fig C)
The power supply indicator light (6) is a green LED. It will only display
green when there is a 240V output available, thus the generator must be
operating.
This indicator will remain on when the
generator is operating and has 240Va.c.
available to the control panel, with or
without appliances connected to the
AC sockets (9). In an overload condition,
there is no 240Va.c. available to the
panel so the green indicator will not
operate.
Preparing the Generator
It is important to check the generator before you commence operating the
unit.
IMPORTANT. Ensure that the engine has oil. When leaving the factory, this
generator has NO OIL in the engine.
NOTE. The engine will not start if the generator has no oil.
Checking the Engine Fuel
IMPORTANT: Fuel goes off after about 3-4 months. If you find your generator
does not start, first change the fuel in the tank with newly purchased fresh
unleaded fuel. Do not use ethanol based fuels.
IMPORTANT: If replacing old fuel from the generator ensure to drain the old
fuel from the carburettor bowl until the new fuel drains from the bowl. Drain
the bowl via the fuel drain screw (10).
WARNING!
• Do not refill fuel tank (26) while engine is running or is hot.
• Check to ensure that the fuel drain screw (10) has been tightened and
that fuel is not leaking.
• Be careful not to admit dust, dirt, water or other foreign objects into the
fuel.
• Wipe off spilt fuel thoroughly before starting engine.
• Ensure you DO NOT fuel the generator in close proximity to any open
flames, lit cigarettes, or hot objects.
AFTER SALES SUPPORT
1300 889 028
(toll free)
C.
e-mail: info.aldi@positecgroup.com
MODEL: . XG-KF2000 • 03/2020 • 700069
17