Zoeller AquaNot 508 Spin Installation Instructions Manual

Zoeller AquaNot 508 Spin Installation Instructions Manual

12 volt dc battery backup pump

Advertisement

Product information presented
here reflects conditions at time
of publication. Consult factory
regarding discrepancies or
inconsistencies.
Patent No.
D740329
PREINSTALLATION CHECKLIST
1.
Inspect your pump. Occasionally, products are damaged during shipment. If the unit or any of the parts are damaged, contact your dealer before using.
2. Carefully read the literature provided to familiarize yourself with specific details regarding installation and use. These materials should be retained for future
reference.
1. Testing for ground. As a safety measure each electrical outlet should be
checked for ground using an Underwriters Laboratory listed circuit analyzer,
which will indicate if the power, neutral and ground wires are correctly
connected to your outlet. If they are not, call a qualified, licensed electrician.
2.
For your protection, always disconnect the power supply from its power
source before handling the components of your DC backup pump or the
primary pump.
3.
Installation and servicing of electrical circuits and hardware should be
performed by a qualified, licensed electrician.
4. All electrical and safety codes must be followed including the National
Electrical Code and all applicable local codes.
5.
It is the owner's responsibility to check the battery and battery
connection at least once a month. Batteries contain acid, and
caution must be taken when handling.
6. Risk of electric shock. These pumps have not been investigated for use in
swimming pools and marine areas.
7.
Prop65 Warning for california residents: Cancer and Reproductive Harm-
www.P65Warning.ca.gov.
This equipment has been tested and found to momply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the module/ product.
- Increase the separation between the equipment and module / product.
- Consult the dealer or an experienced radio / TV technician for help.
MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347
SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961
TEL: (502) 778-2731 • 1 (800) 928-PUMP • FAX: (502) 774-3624
12 VOLT DC BATTERY BACKUP PUMP
INSTALLATION INSTRUCTIONS
SEE BELOW FOR
LIST OF WARNINGS
© Copyright 2019 Zoeller
CAUTION
1.
Make sure there is a properly grounded 115 V receptacle available. Do
not use primary pump circuit. The location must be within 6' (1.8 m) of the
control box and battery. The power supply for your DC control system
plugs directly into the 115 V outlet. DO NOT USE AN EXTENSION CORD.
2.
Make sure the 115 V electrical supply circuit is equipped with fuses or
circuit breakers of proper capacity.
3.
DC emergency pumps are designed for handling clear water. Do not use
in septic tanks to pump effluent or in sewage pits to pump sewage.
4.
Repair and service of your DC backup system should be performed by an
authorized service station.
5. The installation of DC automatic backup pumps requires the use of a variable
level float switch for operation. It is the responsibility of the installing party
to ensure that the float switch will not hang up on the pump apparatus
or pit peculiarities and is secured so the pump will turn "on" and "off".
It is recommended that the pit be 18" (45.7 cm) in diameter or larger to
accommodate both a primary and a DC backup pump.
6.
For indoor use only.
Turbulence caused by high-velocity incoming water can
CAUTION
cause sump pumps to airlock. If this condition exists, the incoming water
must be baffled to avoid excessive turbulence.
REFER TO WARRANTY ON PAGE 2.
Co. All rights reserved.
®
FM3166
0419
Supersedes
New
Visit our web site:
zoellerpumps.com
SEE BELOW FOR
LIST OF CAUTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AquaNot 508 Spin and is the answer not in the manual?

Questions and answers

Summary of Contents for Zoeller AquaNot 508 Spin

  • Page 1 - Reorient or relocate the module/ product. - Increase the separation between the equipment and module / product. REFER TO WARRANTY ON PAGE 2. - Consult the dealer or an experienced radio / TV technician for help. © Copyright 2019 Zoeller Co. All rights reserved. ®...
  • Page 2: Limited Warranty

    Zoeller batteries Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky 40211, Attention: have a 3 year warranty.
  • Page 3: Installation

    7. Determine the position of the DC pump and measure for discharge piping. on battery wire leads. The positive terminal is the larger stud, 3/8" (10 Use that measurement to cut the discharge pipe. Solvent weld that piece mm) diameter. The smaller stud, 5/16" (8 mm) diameter is the negative to the tee. Measure, cut and solvent weld any remaining discharge piping terminal. Apply grease to the terminals to help prevent corrosion. above the tee. © Copyright 2019 Zoeller Co. All rights reserved. ®...
  • Page 4: Initial Start-Up And Operation

    Pump runs but pumps very little or no water. battery post. Check battery. Replace if necessary. Reconnect and refer (a) Verfiy pump is connected completely. to Installation (step 11). (b) Check to make sure pump weep hole is clear and unit is not airlocked. (c) Make sure discharge piping is not blocked. Pump cycles too frequently. (a) Check positions of rubber stops on operational float rod. © Copyright 2019 Zoeller Co. All rights reserved. ®...
  • Page 5 ™ CLAMP OPERATIONAL FLOAT SWITCH DC PUMP 30 AMP FUSE HI-WATER REED SENSOR BLACK LEAD TO NEGATIVE (*OPTIONAL) 12 VOLT BATTERY WHITE LEAD TO POSITIVE SUPPLIED BY USER BATTERY BOX SK3185 © Copyright 2019 Zoeller Co. All rights reserved. ®...
  • Page 6 Flashing No Faults (Green) AC off with no faults (Green) System Ready Charged (Green) Charging (Yellow) Low Battery (Red) No AC Power Battery Bad Battery (Red) Pump Running (Yellow) Pump Ran (Yellow) DC pump Pump Fault (Red) *High Water (Red) Float Status Float Fault (Red) Sensor Activated * If optional high water reed sensor is being used. © Copyright 2019 Zoeller Co. All rights reserved. ®...
  • Page 7: Carbon Monoxide Detectors

    THE AQUANOT BATTERY ® There are millions of batteries manufactured each year, so it is impossible to guarantee consistent quality. A defective battery will never become fully charged and may damage the charging circuits of the Control. It is for this reason that Zoeller Pump Company offers its own line of batteries. We offer both a water/acid deep-cycle battery and a maintenance-free AGM battery which can run the pump continuously for over 5 hours. These times are based on continuous pumping at 8' (2.4 m) of static head. Actual times will vary depending on static head, volume of water entering the pit, and the condition of the battery. Follow these recommendations: • Use a B.C.I. size 27 deep-cycle battery, 175 minute reserve capacity, or larger • Do NOT use a “maintenance-free” battery unless it is an AGM battery...
  • Page 8 MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347 SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961 Visit our web site: (502) 778-2731 • 1 (800) 928-PUMP • FAX (502) 774-3624 zoellerpumps.com © Copyright 2019 Zoeller Co. All rights reserved. ®...

Table of Contents