Associated Electrics DR10 Manual & Catalog
  1. Manuals
  2. Brands
  3. Associated Electrics Manuals
  4. Motorized Toy Car
  5. DR10
  6. Manual & catalog

Associated Electrics DR10 Manual & Catalog

1:10 scale ready-to-run 2wd electric drag car
Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DR10 and is the answer not in the manual?

Questions and answers

Related Manuals for Associated Electrics DR10

Summary of Contents for Associated Electrics DR10

  • Page 2 • Reamer / Hole Punch • Ride Height Gauge (AE #1449) • FT Nut Drivers (AE #1663 - 1668, used with #1655 or 1656 handle) • Turnbuckle Wrench (AE #1114) Associated Electrics, Inc. Customer Service 21062 Bake Parkway. Tel: 949.544.7500 Lake Forest, CA 92630 Fax: 949.544.7501...
  • Page 3 :: Hardware - 1:1 Scale View Button Head (bhcs) Flat Head (fhcs) Ball Bearings 2x4mm (31510) 3x8mm (25201) 3x7x3mm (91475) Aluminum (8545) Aluminum (8553) Titanium (91592) 2.5x8mm (31521) 5x10x3mm (31734) 3x10mm (25202) 3x5mm (31530) Aluminum (8555) Titanium (91593) 3x8mm (31532) 5x10x4mm (25237) Aluminum (8552) 3x12mm (25203)
  • Page 4 This symbol indicates a Racers Tip. until you find the exact size. Each part in the foldout has a number assigned to it for ordering replacement parts. Associated Electrics, Inc. Customer Service 21062 Bake Parkway. Tel: 949.544.7500 Lake Forest, CA 92630 Fax: 949.544.7501...
  • Page 5 1/20 :: Quick Start Guide Battery Charging Steps and Safety: Remove the battery from the vehicle before charging. Place battery on a fire resistant surface. Avoid any contact with water or other liquids. Be sure to select the correct charging mode for the type of battery you are charging.
  • Page 6 :: Quick Start Guide - (cont.) Battery Notes and Tip: Connect the battery as shown. Disconnect the battery when not in use! LiPo: LiPo batteries (lithium polymer) are high current rechargeable batteries. LiPo batteries offer extended run time and peak performance over NiMH batteries. They require a peak detection charger designed specifically for LiPo batteries.
  • Page 7 :: Quick Start Guide - (cont.) Radio System Tuning and Controls: DO NOT hold the trigger when turning on the radio. If using optional battery for transmitter, be sure to plug it in correctly. Plugging in a battery backwards can cause damage.
  • Page 8 :: Front Top Plate and Steering Build - Step 1 91475 91047 91047 3 x 7 x 3 Heavy-duty Heavy-duty Ball Bearing Ballstud, Ballstud, 91391 Steering Bellcrank 91391 Brace Steering Rack 89202 M3 x 12mm Note orientation BHCS of steering rack. 91391 Steering Rack Crush...
  • Page 9 :: Front Suspension Build - Step 1 91047 Heavy-duty 31530 91048 Ballstud, M3 x 5mm 91402 Heavy-duty Caster BHCS Ballstud, Block 91417 Bushing Steering Block 25237 5 x 10 x 4 91417 Bearing Caster Block 25215 71127 M3 Locknut, Front black 89202 Axles...
  • Page 10 :: Front Suspension Build - Step 4 Reakt 71066 Body Front Body Trim Post Post 71032 M2.5 x 14mm SHCS 89202 M3 x 12mm BHCS :: Rear Suspension Build - Step 1 31521 71068 M2.5 x 8mm Rear Arms BHCS 91359 C Mount 91359...
  • Page 11 :: Front Shock Tower and Bumper Build - Bag C - Step 3 :: Rear Suspension Build - Step 3 25211 25187 M3 x 10mm M3 x 14mm BHCS BHCS 89204 M3 x 24mm BHCS 91477 M3 Nut (Black) 71003 Rear Shock Tower :: Rear Shock Tower and Bumper Build - Bag D - DD - Step 1...
  • Page 12 :: Gear Diff Build - Step 3 31350 M2.5 x 10mm FHCS 91463 Gear Diff Gasket * Ensure free outdrive rotation before installation! :: Gearbox Build - Step 1 91437 Gearbox 91466 (right & left) Idler Gear 25616 10 x 15 x 4, Bearing 91132 Idler Gear...
  • Page 13 :: Gearbox Build - Step 3 91478 71038 M3 x 30mm Body Mount FHCS Brace (Left & Right) 89225 M3 x 24mm SHCS 91428 71070 25202 Motor Plate, 25215 M3 x 10mm Blue FHCS Locknuts :: Slipper Build - Step 1 9611 9739 Slipper...
  • Page 14 :: Gearbox Install - Step 2 25211 M3 x 10mm BHCS 25203 M3 x 12mm FHCS :: Gearbox Install - Step 3 25202 M3 x 10mm 25204 71066 FHCS M3 x 16mm Rear Body FHCS Pivot 71038 Rear Body 71066 Mount Rear Body Post...
  • Page 15 :: Rear Hub and CVA Build - Step 2 91436 CVA Wheel Hex Pin 91418 31509 Wheel 91394 M2 x 3mm Hex (rear) Hinge Pin BHCS (rear, outer) Build x2 (right and left side) :: Turnbuckles Build - Step 1 91469 91469 91723...
  • Page 16 :: Turnbuckles Build - Step 3 91469 91469 91723 Ball Cup Ball Cup Turnbuckles, 3x48mm Rear Camber Turnbuckle 23.50mm Racers Tip: Orient the notch Use black grease to the left throughout the (#6588) on the car. It indicates which end threads of the has the left hand threads! turnbuckles for...
  • Page 17 :: Shocks Build - Step 3 91454 Shock Bleeding Steps: Shock Cap Pull shock shaft down. (Molded) Fill shock body 3/4 full with silicone Free fluid. Length Slowly move the shock shaft up and Front/Rear down to remove air from under piston. Shock: 30wt Wait for bubbles to come to surface.
  • Page 18 :: Electronics Build - Step 1 Align the servo horn 90 degrees. 91047 Adjust steering trim once vehicle is Heavy-duty complete. Ballstud, 6mm 91469 Servo Steering 71047 Link 25201 Servo M3 x 8mm Saver FHCS :: Electronics Build - Step 2 91391 Servo Mount...
  • Page 19 :: Electronics Build - Step 4 71023 Receiver Box Grommet * Install the ESC wires and the Servo wires into the wire grommet before installing the grommet into the receiver box! 71023 * Receiver grommet Wire plug can be removed if Grommet you use a personal Plug...
  • Page 20 :: Electronics Build - Step 7 :: Bumpers and Chassis Braces Build - Step 1 Battery 71067 25203 not included! Front M3 x 12mm Bumper FHCS Brace 71048 Battery Foam Spacer 71067 Front Bumper 89202 M3 x 12mm BHCS :: Bumpers and Chassis Braces Build - Step 2 :: Bumpers and :: Bumpers and Build - Step 2...
  • Page 21 :: Bumpers and Chassis Braces Build - Step 4 25211 M3 x 10mm BHCS 71067 Nerf Bar :: Tires and Body Build - Step 1 Clean the tire and wheel bead. 71078 71072 Carefully apply CA glue (tire ad- Wheel, Pre Glued hesive) to the tire bead on both Rear...
  • Page 22 :: Tires and Body Build - Step 3 71082 Reakt Drag Body, Clear 31520 M2.5x6mm BHCS 25215 M3 Locknut :: Tires and Body Build - Step 4 21173 Small Body Clips 31520 31532 M3x8mm M2.5x6mm BHCS BHCS 25215 Locknut 91477 Nuts, M3 Black...
  • Page 23 :: Tires and Body Build - Step 5 :: Tuning Tips Tips for Beginners: Before making any changes to the standard setup, make sure you can get around the track without crashing. Changes to your vehicle will not be beneficial if you can’t stay on the track. Your goal is consistent laps. Once you can get around the track consistently, start tuning your vehicle.
  • Page 24 :: Tuning Tips (cont.) Slipper Clutch: The assembly instructions give you a base setting for your clutch. Turn the nut on the shaft so that the end of the top shaft is flush with the nut. At the track, tighten or loosen the nut in 1/8 turn increments until you hear a faint slipping sound for 1-2 feet on takeoffs.
  • Page 25 :: Shock Springs :: Shocks 91635 12mm Front Spring (54mm) GRN 3.75 5407 Red O-Rings 91636 12mm Front Spring (54mm) WHT 4.10 6299 E-Clip 91637 12mm Front Spring (54mm) GRY 4.45 31327 FT VCS3 Shock Bottom Caps 71051 Shock Body 12 x 27.5mm 71054 Spring Clips and Retainer 91444...
  • Page 26 :: Transmission 7337 .250x.125x.015” Washer 25202 M3 x 10mm FHCS 31532 25203 M3 x 12mm FHCS 7337 25211 M3 x 10mm BHCS 31532 25202 25237 Bearing, 5 x 10 x 4 25616 Bearing, 10 x 15 x 4 91428 31532 M3 x 8mm BHCS 89203 M3 x 16mm BHC...
  • Page 27 :: Optional Ball Differential 6573 Diff Thrust Washer & Bolt 6575 31400 6574 Precision Diff Thrust Balls, 5/64” 6575 Locking T-Nut, Diff Thrust Bolt, & Cover 6582 7666 6581 3/32” Carbide Diff Balls 6582 Diff Thrust Spring 7666 Diff Drive Rings, 2.60:1 91420 7677 Ball Diff Rebuild Kit...
  • Page 28 Steering Block, Hex :: Front Arm 25189 M3 x 22mm BHCS 25215 M3 Locknut, Black 25237 Bearing, 5 x 10 x 4 91417 31509 M2 x 3mm BHCS 89202 31530 M3 x 5mm BHCS 71068 Suspension Arm Set 71127 Front Axle 89202 M3 x 12mm BHCS 91048...
  • Page 29 :: Battery Strap 71048 Battery Foam 71050 Hook and Loop Straps 71050 71050 71048 :: Front Bumper 25203 M3 x 12mm FHCS 25204 M3 x 16mm FHCS 25203 71067 Front Bumper and Nerf Bars 89202 M3 x 12mm BHCS 71067 25203 71067 89202...
  • Page 30 :: Front Shock Tower 21173 Small Body Clips 25201 M3 x 8mm FHCS 25612 M3 Locknut, with flange 31383 Ballstud Washer, 5.5 x 2mm, Blue Aluminum 71003 Pro SC10 Shock Tower Set 91477 91444 71032 M2.5 x 14MM SHCS 71066 Body Posts and Body Mount 25612 89202...
  • Page 31 :: Chassis 6338 Antenna Tube & Cap (black) 25187 M3 x 14mm BHCS 25225 25203 M3 x 12mm FHCS 25204 M3 x 16mm FHCS 6338 25211 M3 x 10mm BHCS 25225 M3 x 3mm Set Screw 31383 Ballstud Washer, 5.5 x 2mm, 6338 Blue Aluminum 31509...
  • Page 32 :: Factory Team and Option Parts :: Reedy Batteries and Chargers 1408 FT Ti Turnbuckle, 2.65”/67mm (blue) AA Alkaline 1.5V (4) 1409 FT Ti Turnbuckle, 1”/25.5mm (sway bar) (blue) 5.0mm 1S-2S Balance Charge lead w/SP Clip (4mm) 1734 FT Blue Body Clip, 4 long, 6 short 4.0mm 1S-2S Balance Charge lead w/SP Clip (4mm) 1735 FT Blue Body Clip, long...
  • Page 33 Flat Sensor Wire 110mm current products, new releases, setup help, tips, and racing info! Flat Sensor Wire 150mm Flat Sensor Wire 200mm Associated Electrics, Inc. Flat Sensor Wire 270mm 21062 Bake Parkway Flat Sensor Wire 125mm Lake Forest, CA 92630-8853 USA Flat Sensor Wire 175mm http://www.TeamAssociated.com...

Table of Contents