Endura Az40 Analyzer - Electrical; Endura Az40 Transmitter - Weight; Safety Standards; Product Symbols - ABB Endura AZ40 Operating Instructions Manual

1.3.6 Endura AZ40 analyzer – electrical
WARNING – Bodily injury
To ensure safe use when operating this equipment, the
following points must be observed:
— up to 240 V AC may be present. Ensure the supply
is isolated before removing the terminal cover
— normal safety precautions must be taken to avoid
the possibility of an accident occurring when
operating in conditions of high pressure and / or
temperature
Safety advice concerning the use of the equipment
described in this manual or any relevant Material Safety
Data Sheets (where applicable) can be obtained from
the Company, together with servicing and spares
information.
1.3.7 Endura AZ40 transmitter – weight
WARNING – Bodily injury
— The transmitter weighs 7.6 kg (17 lb) and must
be mounted in accordance with the information
supplied in the Operating instruction (OI/AZ40-EN).
— Suitable lifting equipment must be available when
installing / removing the transmitter from the
mounting.

1.4 Safety standards

This product has been designed to satisfy the requirements of
IEC61010-1:2010 3rd edition 'Safety Requirements for
Electrical Equipment for Measurement, Control and Laboratory
Use' and complies with US NEC 500, NIST and OSHA.

1.5 Product symbols

Symbols that appear on this product are shown below:
Endura AZ40 | Oxygen and carbon monoxide equivalent (COe) analyzer | COM/AZ40/MOD–EN Rev. A
Protective earth (ground) terminal.
Functional earth (ground) terminal.
Alternating current supply only.
This symbol, when noted on a product, indicates a
potential hazard which could cause serious personal
injury and / or death.
The user should reference this instruction manual for
operation and / or safety information.
This symbol, when noted on a product, indicates a
high temperature hazard which could cause serious
personal injury and / or death.
The user should reference this instruction manual for
operation and / or safety information.
This symbol, when noted on a product enclosure or
barrier, indicates that a risk of electrical shock and / or
electrocution exists and indicates that only individuals
qualified to work with hazardous voltages should open
the enclosure or remove the barrier.
Recycle separately from general waste under the
WEEE directive.
5