Do you have a question about the EFIC452-SS and is the answer not in the manual?
Questions and answers
Kyle Clayton
January 18, 2025
Does the machine have a cleaning mode
James Donald
February 15, 2025
Water is spraying from the top pipe and leaking everywhere. How is the pipe disconnected and cleaned?
1 comments:
Mr. Anderson
February 15, 2025
To disconnect and clean the top pipe of the Frigidaire EFIC452-SS ice maker to stop water from spraying and leaking:
1. Turn Off the Unit – Ensure the ice maker is powered off and unplugged for safety. 2. Disassemble the Water Separator Pipe – If the top pipe is blocked, remove it carefully. 3. Clean Each Hole – Use a slim wire to clear any clogs in the holes of the separator pipe. 4. Reassemble the Pipe – After cleaning, securely reconnect the pipe, ensuring the right end is properly attached to the silicone tube. 5. Check for Leaks – Turn the unit back on and observe to ensure water flows correctly without spraying or leaking.
. ………………………………………..........6 … CLEANING MAINTAINING YOUR MAKER CLEANING MAINTAINING YOUR MAKER USING YOUR ICE MAKER……………….……..………………………………………..........8 …………………………… . …………………………………………….........10 …………………………… TROUBLESHOOTING TROUBLESHOOTING is a pending or registered trademark used under license from Electrolux Home Products, Inc. Made In China USER MANUAL EFIC452-SS...
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others are very important. We have provided many important safety messages manual and your appliance. Always read and obey all safety messages. This is the safety alert symbol: All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”. DANGER WARNING These words mean:...
PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and injury to persons or property. Read all instructions before using any appliance. Do not operate this,or any other appliance with a damaged cord.
Page 4
CAUTION – Risk Of Fire Or Explosion. Flammable Refrigerant Used. Consult Repair Manual/Owner’s Guide Before Attempting To Install or Service This Product. All Safety Precautions Must be Followed. CAUTION – Risk Of Fire Or Explosion. Dispose Of Property In Accordance With Federal Or ...
GETTING TO KNOW YOUR UNIT 1. Water reservoir cover 2. Unit top cover 3. Water separator pipe 4. Evaporator 5. Ice basket 6. Ice scoop 7.Transparent window 8. Control Panel: A. Timer button B. Power button C. LCD Display area 1.Ambient temp and ice making countdown symbol: when display show <M>, ice making countdown,when display show <℉>,means ambient temp.
OPERATING PROCEDURES & MAINTENANCE UNPACKING YOUR ICE MAKER 1. Remove the exterior and interior packaging. Check that ice basket and ice scoop is included. If any parts are missing, please contact our customer service. 2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it 3.
Page 7
1. If the water separator pipe is blocked and there is no water flowing down when you listen the compressor and the water pump inside are still working, please turn off the unit first and disassemble this pipe down, and clean it. Clean the each hole on the pipe wall displayed in following picture.
USING YOUR ICE MAKER Operation panel and display area OPERATION DISPLAY OPERATION AREA AREA AREA TIMER ON/OFF 1. Remove the cover of the water reservoir and pour potable water into water reservoir. And be sure to keep water level below the max. level with FULL mark displayed in following Then move back the cover .
Page 9
last time will be a little longer. In the extreme hot room temperature, ice-making time maybe vary a lot, but it will not exceed 35 minutes. If you think the ice cube is not thick enough, during ice making,press the <+> and <-> to set the ice making lead time.
TROUBLESHOOTING problem reason solution Turn off the unit and add water to Lack of water < > is on <FULL> level, then re-start the unit. Too many ice cube in the Remove the ice cube in the basket < > is on basket The water reservoir has The inlet solenoid valve...
Page 11
DÉBALLER VOTRE MACHINE À GLAÇONS……………………………………………...6 ONNECTER VOTRE MACHINE À GLAÇONS ……………………….………………….6 CLEANNETTOYERETENTRETENIRVOTREMACHINEÀGLAÇONS ..………………….6 UTILISER VOTRE MACHINE À GLAÇONS……………………………………………… 8 DÉPANNAGE…………….………………………………………………………….………… 11 est une marque commerciale en attente ou enregistrée utilisée sous licence par Electrolux Home Products, Inc. Fabriqué En Chine MANUEL DE L'UTILISATEUR EFIC452-SS...
Votre sécurité et la sécurité des autres sont très important LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES Nous avons fourni plusieurs manuels de sécurité importants et votre appareil. Lire et obéir à tous les messages de sécurité,s'il vous plaît C'est le symbole d'alerte de sécurité : Tous les messages de sécurité...
L'UTILISER PRÉPARER VOTRE MACHINE À GLAÇONS POUR LES CONSEILS DE SÉCURITÉ IMPORTANTS Lors de l'utilisation d'appareils électriques, des précautions de sécurité élémentaires doivent être respectées afin de réduire les risques d'incendie, d'électrocution et de blessures aux personnes ou aux biens. Lisez toutes les instructions avant d'utiliser un appareil.
Page 14
DANGER - Risque d'incendie ou d'explosion. Réfrigérant inflammable utilisé. Être réparé uniquement par du personnel de service qualifié. Ne pas percer le tuyau de réfrigérant. ATTENTION - Risque d'incendie ou d'explosion. Réfrigérant inflammable utilisé. Consultez le manuel de réparation / guide du propriétaire avant d'essayer d'installer ou de réparer ce produit.
APPRENDRE À CONNAÎTRE VOTRE UNITÉ 1. Le couvercle du réservoir d'eau 2. Le couvercle supérieur de l'unité 3. Le tuyau de séparateur d'eau 4. L’Évaporateur 5. La corbeille à glace 6. Le scoop de glace 7. La fenêtre transparente 8. Le panneau de commande : a.
PROCEDURES D'EXPLOITATION ET MAINTENANCE DÉBALLER VOTRE MACHINE À GLAÇONS 1. Retirez l'emballage extérieur et intérieur. Vérifiez que la corbeille à glace et la pelle à glace sont incluses. Si des pièces manquent, veuillez contacter notre service clientèle. 2. Nettoyez l'intérieur avec de l'eau tiède et un chiffon doux. Sortez le panier de glace et nettoyez-le.
Page 17
3. Ensuite, utilisez l'eau pour rincer les pièces internes et vider l'eau de l'orifice de vidange en débranchant le bouchon de vidange à l'arrière. 4. L'extérieur de la machine à glaçons doit être nettoyé régulièrement avec une solution détergente douce et de l'eau chaude. 5.
pendant plus de 5 secondes Laisser l'unité commencer le processus de récolte de glace pour faire fondre le glaçon. Il vous aidera à enlever le glaçon dur. Comment vider complètement l'eau du réservoir interne et du grand réservoir d'eau Parce que l'eau dans le grand réservoir d'eau est arrêtée pour drainer le port par la vanne d'eau, si vous voulez vider toute l'eau, s'il vous plaît branchez l'unité...
Page 19
3. Lorsque la machine à glaçons récolte, le symbole < > clignote, l'eau s'écoule du réservoir d'eau supérieur au réservoir d'eau inférieur par l'intermédiaire de l'électrovanne, le symbole < > s'allume, lorsque l'eau dans le réservoir d'eau inférieur est pleine, le symbole < >...
Page 20
Attention Assurez-vous que le réservoir d'eau, le filtre à eau et le séparateur d'eau ne sont pas bloqués, nettoyez-les périodiquement La température de l'eau affectera la capacité de production de glace. Plus la température est basse, plus le cube de glace produira. Plus la température ambiante est froide, plus le glaçon produit.
DÉPANNAGE PrLe Problème La Raison La Solution Éteignez l'unité et ajoutez de l'eau au niveau < > c’est le Fuite d'eau travail <FULL>, puis redémarrez l'unité. < > c’est Trop de glaçon dans le Retirez le cube de glace dans le panier le travail panier Le réservoir...
Need help?
Do you have a question about the EFIC452-SS and is the answer not in the manual?
Questions and answers
Does the machine have a cleaning mode
Water is spraying from the top pipe and leaking everywhere. How is the pipe disconnected and cleaned?
To disconnect and clean the top pipe of the Frigidaire EFIC452-SS ice maker to stop water from spraying and leaking:
1. Turn Off the Unit – Ensure the ice maker is powered off and unplugged for safety.
2. Disassemble the Water Separator Pipe – If the top pipe is blocked, remove it carefully.
3. Clean Each Hole – Use a slim wire to clear any clogs in the holes of the separator pipe.
4. Reassemble the Pipe – After cleaning, securely reconnect the pipe, ensuring the right end is properly attached to the silicone tube.
5. Check for Leaks – Turn the unit back on and observe to ensure water flows correctly without spraying or leaking.
This answer is automatically generated