Modulift CMOD 50 User Instructions

User Instructions
CMOD 50: 8-Point Frame
The CMOD 8-Point Spreader Frame is modular in span and every frame consists of 4 Corner Units and
4 T-Pieces with intermediate Struts that can be bolted into the assembly to achieve different spans.
CMOD 50: 8-Point Frame has an assembled span up to 15m x 11m.
Assembled
Frame
β
β = Sling to
vertical angle (STV)
P1
Span
Strut
T-piece
CMOD 50: 8-Point Frame Specification
Rated at a maximum of 60 tonnes WLL.
● ●
Please see Table 2 for WLL at specific spans.
'Sling to Vertical' angle, β, 45 degrees or less.
● ●
Corner Units and T-Pieces rated at 15 tonnes
● ●
WLL each (60 tonnes combined capacity).
Bolt tightening torque: 150Nm. Spanner size required: 30mm.
● ●
Recommended additional equipment: Torque Wrench, Podger Spanner and Ring Spanner.
● ●
WARNING!
Personnel using this system should be suitably trained, competent and have a clear
● ●
understanding of Safe Slinging procedures.
The use of Modulift equipment must be in accordance with the procedures laid down in
● ●
'Lifting Operations and Lifting Equipment Regulations 1998' (LOLER).
Never exceed stated WLL
● ●
The top sling length is critical to the safe use of the frame
● ●
Modulift UK Ltd tel: +44(0)1202 621511 email: sales@modulift.com www.modulift.com
Fig. 1 – Typical CMOD 8-Point
Spreader Frame Assembly
P2
P3–P6
Corner
Unit
– Adhere to WLL in Table 2 for particular sling angle used.
P2
P3–P6
Table 1 – Component List
Part Ref. Description
P1 Corner Unit
P2 T-Piece
(
length 0.75 x 0.5m each)
P3 4.0m Strut
P4 2.0m Strut
P5 1.0m Strut
P6 0.5m Strut
P7 35t Shackle
P8 25t Shackle
P9
M20 x 65, Grade 8.8, HT Bolts, Nuts & Washers
– Ensure you refer to the correct table.
P7
P9 P8
Weight/item
150kg
(
length 0.5m each)
175kg
140kg
82kg
53kg
38kg
20kg
14kg