Teradek Bolt 10K Quick Start Manual

ULTRA LONG-RANGE
WIRELESS HD VIDEO
Bolt 10K is an ultra long-range
wireless receiver for the most
demanding cinema, broadcast,
and UAV applications. Bolt 10K
receivers support 1080p60
4:2:2 video at up to 10,000 ft
line−of−sight from a Bolt 3000
transmitter.
I
A
B
C
D
E
F
A: On/Off switch D: HDMI output
B: Mini USB port E: 3G-SDI output
C: 6-28V DC input F: OLED display
Teradek regularly releases new firmware versions to improve performance, add new features, or to fix vulnerabilities.
Visit https://www.teradek.com to update your device with the latest firmware.
A
B
C
D
E
H
G
G: Status joystick
H: Menu joystick
I: Battery plate
CONNECT AND POWER
Connect the output from your video source to the SDI/HDMI input on the Bolt 3000 transmitter.
1
Connect the SDI/HDMI output from the Bolt 10K receiver
Connect power to the Bolt transmitter. Power the Bolt receiver with the included A/C adapter or
2
optional battery plate accessory. If using a battery plate, connect a compatible
(AB Gold mount or V-Lock) battery.
Move the power switches on both the transmitter and receiver
3
PAIRING INSTRUCTIONS
After powering the transmitter and receiver, connect a monitor to the video output.
1
Using the Menu joystick (H) on the receiver, select "Pairing."
2
Confirm that "Please activate pairing on TX" is displayed on Bolt 10000
3
receiver's output.
On the transmitter, use a paper clip (or similar) to press the Reset/Pair
4
Mode button (J). After a few seconds, the receiver should display Pairing:
BP00XXXX. If not, power cycle the receiver and the transmitter, then try
again.
Using the Menu joystick on the receiver, select "OK" to finish pairing. This process takes up
5
to a minute. If pairing fails, power cycle the receiver and the transmitter and try again.
DEVICE OPERATION
GENERAL
• Keep the transmitter and receiver at close range for 60 seconds after powering on the devices.
This allows them to scan for and select the best wireless channel.
• For best results when using multiple Bolt systems in the same area, place the transmitters and
receivers a few feet apart from each other.
• Operation of other wireless equipment may interfere with the Bolt. For best results, separate other
wireless transmitters and receivers as much as possible.
MOUNTING
• Bolt 10000 has a 3/8 in threaded hole on the bottom for mounting the included light stand adapter
or any 3/8 in mounting accessory.
• Mount the receiver vertically, keeping the antennas clear of any obstructions.
• Orient the transmitter and receiver so they are parallel to each other.
• For best results, orient the receiver so the front has clear line−of−sight to the transmitter.
NEED MORE HELP?
Support: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
TERADEK SUPPORT STAFF: support@teradek.com or call 888−941−2111 ext2 (Mon−Fri 7am to 6pm PST)
(E, D) to the video input on your monitor.
(A) to the ON position.
J
Bolt 3000 TX