Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Only fully trained and qualified persons should use this equipment. These instructions are not a substitute for user receiving full
supervised training by a qualified person. It is important the user understands the applications, limitations and potential hazards of the product.
1.
SAFETY INSTRUCTIONS
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
p
p
Familiarise yourself with product application and limitations, as well as the specific hazards peculiar to the kit.
3
WARNING! Disconnect the ram from the hydraulic pump before servicing or performing any maintenance on the unit.
p
p
Maintain kit in good order. Replace/repair with genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
3
Use qualified person to lubricate and maintain the ram.
3
Keep the repair kit clean for best and safest performance.
3
WARNING! Ensure you know how much load you are pushing/pulling. Never exceed the maximum pushing/pulling capacity.
p
p
Use only with Sealey hydraulic pump and accessories. Wrong equipment may damage unit and invalidate your warranty.
3
The kit accessories may be used with other popular makes of kit.
3
We recommend the use of BS approved safety impact goggles and heavy duty gloves when working with this kit. Both are available from your
3
authorised Sealey dealer.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
3
If working on an off centre load, pump with care. If you feel undue resistance, stop and re-adjust the set-up.
3
WARNING! Keep your hands, body and clothing away from the kit and accessories when in use. Take any necessary
p
p
precautions to protect your personal safety whilst using the repair kit.
Always be prepared for unexpected load movement, never place yourself or any part of your body in a position that could result in
injury. Always use a crowbar or similar device to manoeuvre the load.
Ensure the hydraulic hose is not bent or kinked but laid out correctly. Avoid damage to the hose (e.g. crushing/cutting).
3
Keep non-essential persons away from the operating area. Be aware of the locations of other persons assisting you.
3
When releasing tension from the load be sure to undo the hydraulic valve VERY slowly.
3
DO NOT operate the kit if any parts are damaged or missing as this may cause failure and/or personal injury.
7
WARNING! DO NOT use for any purpose other than for that which it is designed.
p
p
DO NOT heat accessories as this may weaken them.
7
DO NOT modify accessories for use with this kit.
7
When not in use, place dust cap in end of hydraulic hose and store the kit, in the case, in a safe, dry, childproof location.
3
2.
CONTENTS/SPECIFICATION
Ram Model No. Type.
RE97XC02 . . . . .Push . . . .2000kg . . . . . . .139/240mm . . . . . . . . .No
RE97XC04 . . . . .Push . . . .4000kg . . . . . . . . .42/58mm . . . . . . . . .No
RE97XM04 . . . . .Push . . . .4000kg . . . . . . .275/405mm . . . . . . . . .Yes
RE97XC10 . . . . .Push . . .10000kg . . . . . . .132/189mm . . . . . . . . .Yes
RE97XM10 . . . . .Push . . .10000kg . . . . . . .350/500mm . . . . . . . . .Yes
RE97XM02 . . . . . .Pull . . . .2000kg . . . . . . .422/550mm . . . . . . . . .Yes
RE97XM05 . . . . . .Pull . . . .5000kg . . . . . . .520/650mm . . . . . . . . .Yes
Hook Model No.
RE97XM02.H
2Ton Pull Ram 2000Kg
RE97XM05.H
5Ton Pull Ram 5000Kg
RE97XCKIT
Capacity.
Closed /Open Height. Return Spring
INSTRUCTIONS FOR:
SPECIALIST PUSH AND PULL RAM SET
Model: RE97XCKIT
RE97XCO4
RE97XC10
RE97XMO2
RE97XMO4
RE97XMO5
RE97XM10
RE97XCKIT - 1 - 051104