Table of Contents
Advertisement
Available languages
Available languages
MOunTInG & InSTALLATIOn
G B
SAFETy InFORMATIOn
Installation and commissioning may only be done by an authorised electrician. Mains power (230 V ~/50 Hz) to electrical equipment must be switched off
during installation. Applicable laws and standards of the country in which the device is operated must be observed!
MOunTInG
The 952 JRM is designed for mounting on a 35mm top hat rail acc. EN 50022 in in-/on-wall distribution housing. The devices can be mounted directly
next to each other.
InSTALLATIOn
See supplement „Installation".
COMPACT BuS
The modules are interconnected with a bus line to the bus ports (RJ12).
The „Bus OUT " output must be connected to the „Bus IN " input to the following module.
C o m p a c t 9 5 2 J R M
C o m p a c t 9 5 2 J R M
The first module in the bus must be configured as the master. This module is used to connect common sensors via
Bus In Bus Out
Bus In Bus Out
the compact bus (external sensor data). All of the following modules are configured as slaves. The master/slave
configuration is set in the device menu under BROADCAST (see page 18).
Caution!! Switch off the power supply before disconnecting the bus line.
b u s l i n e
GB-25
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Compact 952 JRM and is the answer not in the manual?
Questions and answers