Yamaha DME Setup Manual page 9

These settings must be made when DME devices are connected via Ethernet cables.
Computer TCP/IP Settings
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
The computer's IP address and TCP/IP filtering must be set up to allow network communication with the DME
device(s).
■ Windows Vista
1
Select [Start] ➞ [Control Panel] ➞ [Network and
Sharing Center] ➞ [Manage network
connections] ➞ [Local Area Connection].
The "Local Area Connection Properties" dialog box will
be displayed.
2
Select [Internet Protocol Version 4 (TCP/Ipv4)]
on the [Networking] tab, then click [Properties].
The "Internet Protocol Version 4 (TCP/IPv4) Properties"
dialog box will be displayed.
3
Click [Use the following IP address] on the
[General] tab.
4
Enter your computer's IP address into [IP
address], the Gateway's IP address into [Default
gateway], and "255.255.255.0" into [Subnet
mask].
n
When the computer and DME devices are connected in
the same subnet as described on
address must be set to that same address as the DME
devices, while the host address must be set to a
different value.
n
When the computer and DME devices are connected in
the same subnet, Set the gateway IP host address to 254.
5
Click [OK].
6
Restart your computer
DME Setup Manual
Computer Network Setup
page 8, the network
■ Windows XP
1
Select [Start] ➞ [Control Panel].
The "Control Panel" is displayed.
2
If the "Control Panel" is in Category display,
click [Switch to Classic View].
3
Double-click [Network Connections] ➞ [Local
Area Connection].
The "Local Area Connection Status" dialog box will be
displayed.
4
Click [Properties] on the [General] tab.
The "Local Area Connection Properties" dialog box will
be displayed.
5
Select [Internet Protocol (TCP/IP)] on the
[General] tab, then click [Properties].
The "Internet Protocol (TCP/IP) Properties" dialog box will
be displayed.
6
Click [Advanced...], then [Properties] on the
[Options] tab.
The "TCP/IP Filtering" dialog will be displayed.
7
Select "Permit All" for TCP Ports, then click
[OK].
The display returns to the "Advanced TCP/IP Settings"
dialog. Click [OK] to return to the "Internet Protocol (TCP/
IP) Properties" dialog.
8
Click [Use the following IP address] on the
[General] tab.
9