Yamaha 007POTO-G0 Owner's Manual page 100

Changing the input patching
3
Move the cursor to the port select popup
button for the desired channel, and press
the [ENTER] key.
The INPUT PORT SELECT popup window will
appear, allowing you to select the input port for the
input channel.
This popup window contains the following items.
1
2
1 Category tab
These tabs select the input ports that are shown in the
popup window. Each tab corresponds to the following
input ports.
●
IN 1-16 {1-32}
Shows INPUT jacks 1–16 {1–32}.
●
SLOT {1/2}
Shows input channels 1–16 of the slot(s) {1/2}.
●
RACK
Shows the outputs of racks 1–8. Use this when you
want to send the output of a GEQ or effect to an
input channel.
HINT
• For details on GEQ and effects, refer to p.157.
●
2TR IN/PB OUT
Shows the 2TR IN DIGITAL jack and the USB
memory recorder's output. Use this when you
want to send the input signal from the 2TR IN
DIGITAL jack or the output signal of the USB
memory recorder to an input channel.
B Port select button
This selects the input port that is assigned to the chan-
nel.
100
LS9-16/32 Owner's Manual
4
Use the category tabs and the port select
buttons to select the input-source port.
5
Move the cursor to the CLOSE button and
press the [ENTER] key to return to the pre-
vious screen.
HINT
• As an alternative to using the CLOSE button, you can return
to the previous screen by pressing the SELECTED CHAN-
NEL section [HOME] key once.
6
If necessary, perform the same steps for
other input channels.
LS9-16