Related Manuals for Yamaha DVD CHANGER
Summary of Contents for Yamaha DVD CHANGER
- Page 1 DVD CHANGER LECTEUR DE DVD CHANGEUR DVD-C740 OWNER’S MANUAL MODE D’EMPLOI NATURAL SOUND DVD PLAYER STANDBY DISC PLAY CHANGE PROGRESSIVE REPEAT...
-
Page 2: Important Safety Instructions
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol warns the user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. - Page 3 - and, most importantly, without affecting your sensitive hearing. Since hearing damage from loud sounds is often undetectable until it is too late, YAMAHA and the Electronic Industries Association's Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels.
- Page 4 YAMAHA will not be held responsible for any damage resulting from use of this unit with a voltage other than as specified.
-
Page 5: Table Of Contents
Introduction Supplied accessories ...2 Notes about discs ...2 Cleaning discs...2 Symbols Used in this Manual ...2 Functional Overview Front Panel ...3 Rear Panel ...4 Remote Control...5 Preparation General Notes on connections ...6 Digital Connections ...6 Analog Connections...6 Video Connections ...6 S-Video jacks ...7 Component Video jacks...7 Composite Video jacks ...7... -
Page 6: Introduction
Introduction Thank you for purchasing this YAMAHA DVD player. This Owner’s Manual explains the basic operation of this DVD player. Supplied accessories – Remote control – Batteries (two AA size) for remote control – Audio/Video cable – Owner’s Manual Notes about discs –... -
Page 7: Functional Overview
Front Panel STANDBY/ON – to switch the player to standby mode or ON Disc Tray – load up to 5 discs on the disc tray NATURAL SOUND DVD PLAYER STANDBY DISC PROGRESSIVE REPEAT DISPLAY – shows the current status of the player DISC (1, 2, 3, 4, 5)/LEDs –... -
Page 8: Rear Panel
Functional Overview Rear Panel VIDEO OUT - COMPONENT – connect to COMPONENT VIDEO input of your AV receiver VIDEO OUT - VIDEO – connect to VIDEO (composite) input of your AV receiver SUBWOOFER – connect to an active subwoofer VIDEO SUB WOOFER COAXIAL OPTICAL... -
Page 9: Remote Control
Remote Control DISC SKIP – to select another disc DIMMER – to select 4 different brightnesses for the display – select title/chapter SOUND MODE – selects required sound mode Stereo, Dolby Surround- compatible or 3D sound RETURN/RESUME – go back to previous menu / continue playback after play was stopped MENU... -
Page 10: Preparation
Preparation General Notes on connections Never make or change connections with the power switched on. Depending on the equipment you wish to connect, there are various ways you could connect this player. Possible connections are shown in the following drawings. Please refer to the manuals of other equipment as necessary to make the best connections. -
Page 11: S-Video Jacks
MONITOR COMPATIBILITY WITH THIS MODEL 525P DVD PLAYER, PLEASE CONTACT OUR CUSTOMER SERVICE CENTER. This unit is compatible with the complete line of YAMAHA projectors, including the DPX-1, LPX- 500, PDM-1 and DPX-1000. Preparation Use commercially available coaxial cables. Receiver (and TV) with component input is required. -
Page 12: Inserting Batteries Into The Remote Control
Preparation Inserting batteries into the Remote Control 1 Open the battery cover. 2 Insert batteries (AA size) with the correct polarity as indicated by the + and - symbols inside the battery compartment. 3 Close the cover. CAUTION! – Remove batteries if they are exhausted or not to be used for a long time. -
Page 13: Menu Bars On Tv Screen
Menu Bars on TV Screen Operations can be carried out directly via the multiple menu bars on the TV screen. The following functions are available via the menu bars. Pressing ON SCREEN repeatedly will toggle through menu bar 1, menu bar 2, menu bar 3 and menu bar OFF: Menu bar 1 From the left,... -
Page 14: Picture
Preparation Picture – TV Shape Select the aspect ratio of the TV to be connected. 16:9 when you connect a wide-screen TV to this player. 4:3 LETTER BOX when you connect a normal TV to this player. Displays a wide picture with black bands displayed on the upper and lower portions of the TV screen. -
Page 15: Sound
– TV System (NTSC/PAL Conversion) Allows you to select between PAL, NTSC and AUTO mode depending on your TV. The conversions supported are as follows: Disc Type Format NTSC NTSC NTSC Supported NTSC NTSC NTSC 1 In the Personal Preferences Menu, select TV System. - Page 16 Preparation Dolby Surround-compatible: Select this setting when using an equipment with a Dolby Surround Pro Logic decoder. In this setting, the 5.1 audio channels (Dolby Digital, MPEG-2, DTS) are downmixed to a Dolby Surround-compatible 2- channel output. 3D-Sound: In a setup without rear speakers (analog stereo output), 3D Sound remixes the six channels of digital surround into a two-speaker output while retaining all of the original audio...
-
Page 17: Language
Language Selecting disc languages: Menu/Audio/Subtitle language This is to select the audio language, subtitle language and the language used in TV screen menus or DVD menus which will always be used for every disc to be played back. If the language selected is not available on the disc, the default language designated by each disc will be selected. -
Page 18: Operation
Operation Basic Playback 1 Press STANDBY/ON on the front panel. 2 Press OPEN/CLOSE / on the front panel to open disc loading tray. 3 Place the chosen discs in the tray, with the label facing up. 4 Press PLAY B. The disc tray closes and playback starts automatically with all the loaded discs on the tray in sequence. -
Page 19: Video Cd And Super Video Cd
Video CD and Super Video CD The current VCD 2.0 and Super Video CD 1.0 standard features are: Support following VCD and SVCD formats: Features Video CDs 2.0 Video MPEG-1 bit rate constant 1,150 Kbps resolution NTSC 352x240, 29.97Hz resolution PAL 352x288, 25Hz Still picture (photo) MPEG-1... -
Page 20: Special Dvd Features
Operation Special DVD Features DVDs may contain menus to navigate the disc and access special features. Press the appropriate numerical key or use 4, 3, 2, 1 to highlight your selection in the DVD menu and press ENTER/OK to confirm. Title/Disc menu 1 Press MENU. -
Page 21: General Features
General Features Note: – Unless stated, all operations described are based on remote control use. Some operations can be carried out using the menu bar on the TV screen. Moving to another title/chapter When a disc has more than one title/track or chapter, you can move to another title/chapter as follows: 1 Press ON SCREEN, then select W or X in the... -
Page 22: Repeat
Operation Repeat Repeat chapter/title/disc Each time you press REPEAT, the front display changes as follows; REPEAT CHPT REPEAT OFF RPT ALL DSC REPEAT CHPT*: repeat the current chapter REPEAT TITL: repeat the current title REPEAT DISC*: repeat the entire disc RPT ALL DSC: repeat all discs loaded on the tray REPEAT OFF: exit repeat mode * This feature may not be available with some... -
Page 23: Favorite Track Selection Across Disc
4 Use 1, 2, 3, 4 to pan across the screen. 5 When ENTER/OK is pressed only the panned picture will be shown on the screen. 6 To exit ZOOM mode, select zoom factor to “Off” (zoom factor 1) in the menu bar. Note: –... -
Page 24: Mp3 Disc Features
Operation Storing album/title 1 Press 4 to select ALBUM/TRACK. Albums are for MP3 and Tracks for (S)VCD. 2 Use 2 and 1 to select the require Album/Track. 3 Press ENTER/OK to store the entire selected Album/Track. The Album/Track number will be added to the program list. -
Page 25: Album/Title Playback
Album/Title Playback This feature allows you to view and select the next or previous MP3 disc Album/Title. 1 Press 3/4 to scroll through the previous or next Album. 2 Press 1/2 to scroll through the previous or next Track. 3 You can also select the desired album/track number directly using the numeric keys on the remote control. -
Page 26: Access Control
Access Control Child Lock Activating/deactivating the Child Lock 1 When disc playback is stopped, select ACCESS CONTROL in the Personal Preferences menu using 3/4. 2 Enter a 4-digit code of your own choice twice. 3 Move to “CHILD LOCK” using 3/4. 4 Move to Ç... -
Page 27: Activating/Deactivating Parental Control
Also note that at the time of release of this player, certain aspects of the technical standards had not been settled between set makers and the disc industries. On this basis, YAMAHA cannot guarantee the Child lock Parental level functioning of the PARENTAL CONTROL... -
Page 28: Troubleshooting
Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. Problem No power No picture... -
Page 29: Specifications
PLAYBACK SYSTEM DVD Video DVD+RW DVD+R Video CD and SVCD CD (CD-R and CD-RW) MP3 CD TV STANDARD (PAL/50Hz) (NTSC/60Hz) Number of lines Playback Multistandard VIDEO PERFORMANCE YUV output Y: 1Vpp into 75 ohm Pr/Cr Pb/Cb: 0.7Vpp into 75 ohm S-Video output Y: 1Vpp into 75 ohm C: 0.3Vpp into 75 ohm... - Page 30 YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA CORPORATION YAMAHA MUSIC AUSTRALIA PTY, LTD.