Dpf Regen Display Status; Passive Regeneration; Automatic Regeneration; Inhibited (Disabled) Regeneration - Vermeer Navigator D20x22 II Series Operator's Manual
Horizontal directional drill
Hide thumbs
Also See for Navigator D20x22 II Series:
- Operator's manual (260 pages) ,
- Maintenance manual (78 pages)
Table of Contents
Advertisement
DPF Regen Display Status
•
OFF: When OFF, passive regeneration is underway.
•
AUTO: Automatic regeneration is underway.
•
PARKED MODE: Machine functions are locked out, preparation for a
forced regeneration.
Passive Regeneration
The DPF is self-cleaning and generally requires no operator action. Passive
regeneration means the engine is operating at a high enough temperature
(more than 570°F/300°C) to burn particulate as it is created, and none is
being emitted.
Automatic Regeneration
When particulate matter builds up, the engine regenerates automatically. Machine operation is not interrupted.
NOTICE: Coolant temperature must be 150°F (65°C) or higher for an automatic regeneration to occur.
Inhibited (Disabled) Regeneration
Inhibit (disable) regeneration only if high exhaust temperatures pose a fire hazard, such as in confined spaces.
Scroll to "Inhibit Regen" (7) and press Enter Key to turn it ON.
Certain engine conditions also inhibit regeneration:
•
out of neutral
•
park brake off
•
low exhaust temperature
•
engine cold
If regeneration is underway and the throttle is adjusted, regeneration will be interrupted.
D20x22 Series II Navigator HDD
7
Electronic Controller 21-17
- Quick Links:
- Engine
- Operator Warnings and Fault Messages
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Navigator D20x22 II Series and is the answer not in the manual?
Questions and answers
Drill position fault ! Kelly will not go back !
A drill position fault where the Kelly will not go back on a Vermeer Navigator D20x22 II Series could be caused by the following issues:
1. Remote Lockout System – Ensure the transmitter is within range, the machine is running, and it is in Drill mode with the operator seated at the controls. If the system is not functioning properly, follow the lockout procedure without the remote system until it is repaired.
2. Hydraulic System Issues – A clogged or dirty hydraulic filter could restrict fluid flow. Check if the filter is clean and installed correctly. A backward-installed filter head can prevent proper relief function.
3. Drilling Fluid Pump Oil – If the oil appears milky, water may be seeping past plunger rod seals, which could affect hydraulic operation.
4. Planetary Gearbox Oil Level – Ensure the oil level is correct. If the drain plug is not positioned correctly, it may cause improper function.
If the problem persists, contacting a Vermeer dealer for further diagnosis is recommended.
This answer is automatically generated
@Bart williams how to reset fault?
What oil filter does a 20x22s2 use and oil ?
The Vermeer Navigator D20x22 II Series requires engine oil and filter changes as part of its maintenance schedule. However, the specific oil filter model is not mentioned in the provided context. For hydraulic oil, it recommends using ISO 10 or ISO 22 oil.
This answer is automatically generated