Velocity Adjustment; Detents - PLANET ECLIPSE EMF100 User Manual

24 QUICK START

VELOCITY ADJUSTMENT

FIG-1
Insert a 1/8 hex key into the velocity adjuster screw to alter the
A B
velocity of the marker.
Adjusting the velocity:
Turn the hex key clockwise to reduce velocity.
1
Turn the hex key counter-clockwise to increase velocity.
2
Fire two clearing shots after each velocity adjustment for an
3
accurate velocity reading.
DO NOT turn the adjuster screw in too far. This will prevent the
1
EMF100 from firing.
DO NOT exceed 300 FPS when using .68 calibre paintballs.
2
DO NOT exceed 300 FPS when using shaped rounds.
3
WARNING!
ALWAYS conform with the velocity limits of the venue and/or local laws.
ALWAYS wear correct protective equipment when firing your marker.
NEVER point your marker in the direction of other people when not on the field.
ALWAYS be aware of where the barrel is facing when adjusting the velocity.
EMF100
FIG-1
- +
B 1
1/8
A
WARNING
25 QUICK START

DETENTS

The rubber detents (see Fig-2) hold each paintball in place
until ready to fire. This prevents paintballs from rolling down
the barrel and maintains feed consistency.
These can be removed for cleaning or replacement.
FIG-1
Use a 5/64" (2mm) hex key to remove the detent cover
A
screw by rotating counter-clockwise. This will release the
B
detent cover (see Fig-2).
C
FIG-2
To remove the detents simply use a small hex key, or
D
your finger tips, to gently lift the rubber detent from its seat.
Detent cover screw
B
6-32UNC x 5/16
countersunk socket screws
Detent cover
C
Rubber detent
D
The elements within this diagram apply to both sides of the
marker.
EMF100
FIG-1
B
C
A
5/64
FIG-2
D
B C