Needle Bar Height - Viking Huskystar 207 Service Manual

NEEDLE BAR HEIGHT

When the tip of shuttle hook meets the left side of the needle (B) in ascending travel of the
needle from its left and lowest position, the distance between the top of the needle eye and
the tip of the shuttle hook should be in the range of 2.9 and 3.5mm (C).
To adjust.
1. Remove the face cover.
2. Set the stitch selector dial at (
zigzag dial at "0".
3. Open the bed cover plate.
4. Remove the shuttle race ring.
5. Turn the hand wheel toward you until the tip of the shuttle hook meets the left side of the
needle (B).
6. Loosen the hexagon socket screw (A).
7. Adjust the height of the needle bar by moving the needle bar (D) upward or downward
without turning it.
8. Tighten the screw (A).
9. Attach the shuttle race ring.
10. Attach the face cover.
( B )
Huskystar 207, 215
) for Model 207. For Model 215, set it at (
( C ) 2,9 ~ 3,5mm
) and
( A )
15