Table of Contents
Advertisement
Code
Door close
E1
Drain
E2
E3
Water inlet
E4
E5
Motor
E6
Communication between
display & electronic module
E8
Not Drying
E9
Not Drying
E10
E11
Not Drying
E12
Not Drying
E13
Not Drying
DIAGNOSTIC MENU
Description
Component
Door Switch
Drain Pump
Pressure Switch
Thermal Protector
+Electronic Module
Communication
Cable
Temp. sensor
(@rear-bottom of tub)
Temp. sensor
(@front of heater housing)
Water level sensor
Temp. sensor
(near the blow fan motor)
Fan Motor
Heating Element
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Super Combo 4400 and is the answer not in the manual?
Questions and answers
how do you program an extra spin dry cycle?
Door jamed
If the door on the Equator Super Combo 4400 is jammed and you receive error code E1, try the following steps:
1. Power Reset: Unplug the washer for five minutes, then plug it back in to see if the error clears.
2. Manual Reset: Press and hold the "Cancel" or "Stop" button for three seconds. If that does not work, try the same with the "Power" button.
3. Check the Door Lock: If the door remains jammed, the door lock mechanism may need to be replaced.
4. Check the Control Board: If the door sensor is not working properly, the computer control may need to be replaced.
If the issue persists after these steps, further inspection or part replacement may be necessary.
This answer is automatically generated