Pcl Driver; Adjusting Color - Xerox COLORQUBE 8570 User Manual

Troubleshooting
To set the PostScript driver print-quality mode from the printer control panel:
1. Select Printer Setup and then press the OK button.
2. Select PostScript Setup > OK.
3. Select Print-Quality Mode > OK.
Select the desired mode and press OK.
4.

PCL Driver

Set the print-quality mode for the PCL driver on the printer control panel or from CentreWare IS.
Print-Quality Mode
PCL Standard (default)
PCL Enhanced
To set the PCL driver print-quality mode from the printer control panel:
1. Select Printer Setup and then press the OK button.
2. Select PCL Setup > OK.
3. Select Enhanced Mode and then press OK to change the setting to On for Enhanced Mode, or Off,
for Standard Mode.

Adjusting Color

This section includes:
• Automatic Color Correction
• Using Color Sampler Pages
Note: This section applies to the PostScript printer driver only.
Color can be adjusted to approximately match the medium used to display it, such as RGB for your
computer monitor, and CMYK color and Spot color for printing.
Automatic Color Correction
Automatic color correction can be set at the printer control panel and in the PostScript driver settings.
For setting color correction in the driver, see
To automatically calibrate color at the printer control panel:
1. Select Printer Setup and then press the OK button.
2. Select PostScript Setup > OK.
3. Select Color Correction > OK.
166 ColorQube 8570/8870 Color Printer
User Guide
Type of Print Job
General-purpose mode for full-speed printing.
Best mode for presentations. Produces superior text resolution and
vibrant, saturated color prints.
on page 166
on page 167
Adjusting Color Correction on page 103.