Storage And Disposal - Husqvarna CF 11M Operator's Manual

Problem
The vibration speed
in the concrete vibra-
tor is too low.
The product makes
much noise.
Storage
• Clean the product before storage.
• Keep the product in a dry and frost-free area.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal of the product
• Obey the local recycling requirements and applicable
regulations.
• When the product no longer is used, send it to the
dealer or discard it at a recycling location.
8
Cause
There is overload in the product.
The concrete vibrator is defective and the
amperage consumption is too high.
The product does not give sufficient power.
The product is connected to the incorrect
network frequency.
The bearings are worn out or broken.
The input voltage or frequency is too high.

Storage and disposal

Solution
Make sure that the total nominal consump-
tion of the connected concrete vibrators is
lower than the nominal output from the prod-
uct.
Replace the concrete vibrator.
Let an electrician do a check of the input volt-
age. The input voltage must be between +10
to -5% nominal. The frequency must be ±2%.
Use the correct product for the given fre-
quency and voltage.
Replace the bearings.
Let an electrician do a check of the input volt-
age. The input voltage must be between +10
to -5% nominal. The frequency must be ±2%.
1381 - 002 - 12.03.2020