Fault Codes; Fault Number Coding - Vislink ADVENT DCU5000 Operation Handbook

Advent Communications
4.

FAULT CODES

4.1.

FAULT NUMBER CODING

DCU5000 Fault List
Fault Code
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11
F12
F13
F14
F15
F16
F17
F18
F19
F20
F21
F22
F23
F24
F25
F26
F27
F28
F29
F30
F31
F32
F33
F34
F35
F36
F37
F38
F39
F40
F41
F42
F43
F44
F45
F46
F47
F48
F49
F50
F51
F52
F53
F54
F55
F56
F57
F58
F59
F60
209297 – DCU5000 Drive Control Unit
Alarm Latched Brief Description
+12V power supply voltage low.
+36V DC motor supply failure.
Motor drive module inhibited.
Inclinometer failure.
Inclinometer suspect.
Drive stall detected.
Drive freewheel detected.
Drive end of travel detected.
Waveguide polarisation switch failure.
Azimuth sensor failure.
Elevation sensor failure.
Polarisation sensor failure.
Elevation deployment sensor failure. (Lynx 2000)
Feedarm deployment sensor failure. (Lynx 2000)
Elevation stow sensor failure. (Lynx 2000)
FPGA programming failure.
Manual brake override on.
Azimuth axis stowing failure.
Elevation axis stowing failure.
Polarisation axis stowing failure,
Elevation deployment axis stowing failure. (Lynx 2000)
Feedarm deployment axis stowing failure. (Lynx 2000)
Power up state suspect.
Stow sensor power supply alarm.
MRD power supply alarm.
Inclinometer power supply alarm.
FPGA watchdog triggered.
GPS comms. failure
Compass comms failure.
Feed drive failure.
Handheld Controller override active.
Alarm Error.
Fin 1 over temperature.
Fin 2 over temperature.
Fin 3 over temperature.
Fin 4 over temperature. (DCU4000 only)
Fin 5 over temperature. (DCU4000 only)
WGS power supply alarm.
Fan power supply alarm.
Brake power supply alarm.
Feed power supply alarm. (DCU4000 only)
GPS/Compass power supply alarm.
Status power supply alarm.
Azimuth brake disconnected.
Elevation brake disconnected.
Polarisation brake disconnected.
Axis 4 brake disconnected.
Axis 5 brake disconnected.
Main Unit fan service warning.
Heatsink fan service warning.
2
E PROM checksum error.
Softlimit data error. Reverted to defaults.
Wooded Area data error. Reverted to defaults.
Calibration data error. Reverted to defaults.
FPGA compatibility warning.
External flash erasing/writing error.
Antenna Type alarm.
Heatsink fan stall detected.
HMR3300 temperature warning.
HMR3300 temperature alarm.
Page 13 of 42