Web Page Moderator Setup; Admin Password - Extron electronics ShareLink 200 N User Manual

Web Page Moderator Setup

Figure 25.
The Web Page Moderator password is used to access the moderator page. Use this screen
to change the moderator password as follows.
NOTE: The factory configured password for all accounts has been set to the device
serial number (passwords are case sensitive). Performing a reset sets this password to
"moderate" (see
To change the moderator password:
1. Enter the new password in the Enter New Password field.
2. Re-enter the password in the Confirm New Password field.
3.
Click Apply to activate the new moderator control password.
You may also enable or disable Web Page Moderator Access by clicking the Enable or
Disable radio buttons.

Admin Password

Figure 26.
The Admin password is used to access the Configuration pages. Use this screen to change
the Admin password as follows.
NOTE: The factory configured password for all accounts has been set to the device
serial number (passwords are case sensitive). Performing a reset sets this password to
"configure" (see
1.
Enter the new password in the Enter New Password field.
2. Re-enter the password in the Confirm New Password field.
3. Click Apply to activate the new moderator control password.
Web Page Moderator Setup
Reset to Default
Admin Password
Reset to Default
ShareLink 200 N • Using the Embedded Web Pages
on page 34 for reset instructions).
on page 34 for reset instructions).
32