Operation - Luminar Outdoor 56521 Owner's Manual & Safety Instructions

Operation

1. Check that the Power Cord / Controller is connected
to the String Lights then connect to 120 VAC outlet.
2. Use the Remote Control to turn the lights on/off.
Also use it to select color and mode changes.
3. On the Remote Control, remove the pull-
out Tab to activate the battery.
4. Point the Remote Control at Controller and
press selection buttons as desired.
1
2
3
4
5
Programming and Resetting the Remote Control
1. Reset the Remote Control if it is not working
properly or has been replaced.
2. To Reset, turn power OFF by unplugging
the Power Cord / Controller.
3. Press and hold the Remote Control's ON button.
4. While holding down the ON button, plug
power cord back into the outlet and point
the Remote Control at the Controller.
Item 56521
6
7
8
For technical questions, please call 1-888-866-5797.
Pull out Tab to activate battery.
Button Selection
1 ON: Turns lights on.
OFF: Turns lights off.
2
BRIGHTNESS: Press ▲ / ▼
3 to choose brightness level (only
works in single color mode).
SPEED: Press – / + to
decrease or increase color
4
changing speed (only works
in color combination mode).
MODE: Press to select
5
a color combination.
RED: Press to change
6
light color to red.
GREEN: Press to change
7
light color to green.
BLUE: Press to change
8
light color to blue.
WHITE: Press to change
9
light color to white.
5. The String Light's bulbs should flash 3
times signifying the Remote Control has
been successfully reprogrammed.
6. Release the On button.
Back of
Remote
Control
Page 5