Advertisement
Advertisement
Table of Contents
Related Manuals for Jensen Octane XDA91RB
Summary of Contents for Jensen Octane XDA91RB
- Page 1 XDA91RB, 92RB, 94RB INSTALLATION / OWNER’S MANUAL...
- Page 2 XDA SERIES Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) •...
-
Page 3: Connection Descriptions
XDA SERIES Connection Descriptions NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used as a general guideline only. Power Wire (+12V) • Disconnect negative battery terminal before proceeding. Consult a qualified technician for instructions if you are unsure. - Page 4 XDA SERIES Audio Inputs and Controls XDA91RB XDA92RB XDA94RB Line Output Do not place anything in this area that Line Input could block the radio waves, as this High Level Input may be a problem with your Bluetooth Reset connection.
-
Page 5: Power And Speaker Connections
XDA SERIES Power and Speaker Connections XDA91RB XDA92RB XDA94RB Power/Protect LED +12V DC Battery Connection Ground Connection Fuse(s) Remote Turn On Speaker Connections... -
Page 6: Typical Wire Routing
XDA SERIES Typical Wire Routing XDA91RB... - Page 7 XDA SERIES Typical Wire Routing XDA92RB...
- Page 8 XDA SERIES Typical Wire Routing XDA94RB...
-
Page 9: Amplifier Connections
XDA SERIES Amplifier Connections Speaker Connections Connect speaker wires 2 Speakers (stereo) Speakers (bridged) observing polarity. The minimum impedance load for the amplifiers is 2 ohms stereo and 4 ohms bridged. Use of loads lower than these is not recommended and may cause amplifier damage. - Page 10 XDA SERIES Controller App Download/Installation Scan the above QR Code to download the Jensen Octane DSP Amplifier Controller app from the Apple App Store or Google Play Store onto your smartphone or tablet. Use the app to control features including: X-Over, EQ, RGB Light Customization, Volume and other amp settings directly from your smartphone or tablet via Bluetooth.
- Page 11 XDA SERIES Bluetooth Pairing with App and AMP Step 1 : Touch the BT icon Step 2 : Touch the Scan icon to search the Bluetooth amp. Step 3 : Bluetooth amp list to show what amp is paired. (If only one amp is installed, one amp model number is displayed.) Step 4 : Select the amp model number you want to install from the device list...
- Page 12 XDA SERIES JENSEN DSP AMP App Operation The input level control (gain) is used to obtain the best Input level Control possible match between the head unit audio output (Master Level at HOME and the amplifier input. Begin by turning the input level Mode) control fully counterclockwise.
-
Page 13: Specifications
XDA SERIES Specifications XDA91RB Power Output •240 Watts RMS x 1 channels @ 4 Ohms •400 Watts RMS x 1 channels @ 2 Ohms •600 Watts RMS x 1 channels @ 1 Ohm Peak Music Power Output: 1200 Watts Signal to noise ratio: 68dBA (reference : 1 Watt into 4 Ohms) Frequency response: 20Hz–... -
Page 14: Troubleshooting
XDA SERIES Troubleshooting Problem Cause Action +12V wire not connected or incorrect Check connections for proper voltage voltage. REM wire not connected or Unit will not turn on (11~16VDC) incorrect voltage (no power LED GND wire not connected Check connection to ground indicator) Fuse(s) blown Replace fuse(s) -
Page 15: One-Year Limited Warranty
Who is covered? This warranty is extended to the original retail purchaser for products purchased from an authorized Jensen dealer and used in the U.S.A. What is covered? This warranty covers all defects in material and workmanship in this product. The... -
Page 16: Fcc Compliance
XDA SERIES FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 17 XDA SERIES Notes...
- Page 18 XDA SERIES OWNER’S MANUAL The Bluetooth® word mark and logos are owned by the Bluetooth® SIG, Inc. Other trademarks and trade names are those of their respective owners. Customer Support 1-888-921-4088 (Monday-Friday, 9AM-5PM EST) Visit https://www.jensenmobile.com Designed and Engineered in USA All rights reserved.
Need help?
Do you have a question about the Octane XDA91RB and is the answer not in the manual?
Questions and answers
Why is the EQ setting not showing on app