Corghi Artiglio Master 28 Operator's Manual page 56

"TOE": "ENCODER TIME-OUT" SIGNAL.
THIS APPEARS WHEN THE CARD DOES NOT RECEIVE SIGNALS FROM THE
ENCODER FOR TWO SECONDS AFTER RESETTING TO 28 INCHES.
It may be necessary to replace the actuator, the card or the encoder cable
"ENC": "ENCODER" SIGNAL.
THIS APPEARS WHEN THE CARD DOES NOT RECEIVE SIGNALS FROM THE
ENCODER DURING THE PHASE OF RESETTING TO 28 INCHES.
It may be necessary to replace the actuator, the card or the encoder cable
IN THE CASE OF "TOE" AND "ENC" THE MACHINE SWITCHES TO MANUAL MODE,
MAKING IT POSSIBLE TO MOVE THE WHEEL SUPPORT ONLY WHEN PRESSING THE UP
OR DOWN BUTTON
It may be necessary to replace the actuator, the card or the encoder cable
"EFC": "LIMIT SWITCH ERROR" SIGNAL:
THIS APPEARS WHEN THE X AND Y AXIS LIMIT MICROSWITCHES DO NOT
WORK.
Check the connection of the limit microswitches and if one of them is broken
"ROT": INCORRECT ROTATION DIRECTION SIGNAL:
THIS APPEARS WHEN THE ENCODER CHANNELS ARE CONNECTED
INCORRECTLY, INVERT THE CONNECTIONS.
Invert the poles of the encoder power supply cable
Risk of injury or death
The "Spare parts" handbook does not authorise the user to carry out work on the
machine with the exception of those operations explicitly described in the User
Manual. It only enables the user to provide the technical assistance service with
precise information, to minimise delays.
8. MAINTENANCE
When the machine is disconnected from the air supply, the devices bearing
the sign shown above may remain pressurised.
The "Spare parts" handbook does not authorise the user to carry out work on the machine
with the exception of those operations explicitly described in the User Manual. It only
enables the user to provide the technical assistance service with precise information, to
minimise delays.
138
CAUTION
DANGER
CAUTION
Artiglio Master 28 Operator's manual