Siemens AP-220-MNT-W3 Installation Manual

Package Contents
Mounting bracket

RJ45 couplers (2)

RJ45 cables (2)

M3 x10mm pan head screws (6)

T6 Torx security screw

AP-220-MNT-W3 Drill Template

AP-220-MNT-W3 Mount Kit Installation Guide (this document)

Introduction
The AP-220-MNT-W3 Mount Kit offers a secure mounting solution for 220 Series access points. This mount
kit attaches to standard single and dual gang wall boxes, or mounts to a flat surface, such as a wall or
ceiling.
Installing the AP-220-MNT-W3 Mount Kit
Refer to the steps below for installing your AP-220-MNT-W3 Mount Kit.
To install the AP-220-MNT-W3 onto a flat surface, see
the mounting bracket onto a wall box, see
Installing the AP-220-MNT-W3 to a Flat Surface
1. (Optional) Remove one or both punch-out panel(s) on the sides of the mounting bracket by pressing
firmly, as shown in
Figure 1 Removing the punch-out panels from the mounting bracket
0511857-01 | October 2015
AP-220-MNT-W3 Mount Kit
Installing the Mount Housing onto a Wall
Figure 1.
Installation Guide
Installing the AP-220-MNT-W3 to a Flat Surface. To install
Box.
1