3.5.10 Resetting The Fdu - Kaba ILCO FDU User Manual

Front Desk Units - Using and Programming
11. Notify the locks of the new Hotel Code by swiping a Hotel Restart key-card
through every lock in the property. The keycard is valid only once in each lock.
The lock will provide a response by flashing green once but will remain closed.
IMPORTANT: The Hotel Restart has now been completed. Because the
previously issued keycards used a Hotel Code that is no longer
recognized by the locks or the FDUs, all required keycards
including Emergency, Staff, Guest, Authorization, Passage, etc.,
required to operate the system must be re-encoded and re-issued.
Previous PINs are now revoked and should be reassigned. When
encoding Staff keycards, remember to print out the information of
each keycard created in order to record each sequence id.

3.5.10 Resetting the FDU

Purpose:
Minimum keycard required:
To reset the FDU, use a pin or flattened paper clip to depress the reset button located
behind the hole on the bottom of the FDU as shown in the image above.
If the system has been configured to hide the date, time and hotel prompts, as per Section
3.5.7 - Hiding the Language, Date and Time Prompts, then the FDU will reset and after a
few seconds the main screen will appear and the system is ready to function as before.
If the system has not been configured to hide the language, date, time and hotel prompts,
the FDU will reset, and after a few seconds show the initial configuration screen,
Kaba Ilco Lodging Access Control System
To reset the FDU if it becomes frozen (permanently
stuck at one step or screen).
N/A
53